2006 Cadillac SRX V6 - Answered Questions & Fixed issues
Wont start after refueling
Hesitates after refueling, have someone check the FPR, Fuel Pump and Filter.
If you have junk in the tank, it will circulate when you add fuel to the system.
2012 srx moon roof stuck in vent position
Most times when that happens it could be a mechanical blockage. In the tool kit that came with the car there should be a hex tool to manually close the roof. There should be an access panel at the front with a pop off cover. If you remove that cover there should be a female hex that the tool fits into to manually close the roof. If you have the female hex on the sunroof but no tool, most times the correct size allen/hex wrench will do in a pinch. Try opening the sunroof fully with the tool and verify there is nothing in the rails or lead screws the will keep it from closing fully. Also check for a blown fuse to the sunroof.
12/23/2018 7:24:47 PM •
Cadillac SRX...
•
Answered
on Dec 23, 2018
•
330 views
What causes message rear door open on the DIC? The liftgate will not open or close.
Door ajar switch possibly . The lift gate not working is a different matter . Could be any number of thing's .
Power Liftgate System Components
• Liftgate motor assembly
• Liftgate latch
• Liftgate module (LGM)
• Liftgate side upper sensor - left
• Liftgate side upper sensor - right
• Liftgate handle switch
• Liftgate close switch
• GMLAN serial data link
• PWR LIFT GATE 30 amp fuse
• PLG 10 amp mini-fuse
Your best bet take it to a qualified repair shop that has the diagnostic tool that can communicate with the lift gate control module , too check for DTC'S - diagnostic trouble code's .
Liftgate Module
The liftgate module controls the liftgate motor, liftgate clutch, and liftgate latch based on various inputs. The liftgate module also performs diagnostics on these inputs and outputs and will disable liftgate functionality and set DTCs should a fault be detected. The liftgate module is secured to the motor assembly at the left rear of the vehicle. The module requires a liftgate position learn procedure be performed when replacing. This allows the module to learn the full open and full closed positions of the liftgate.
DTC B153A 00: Liftgate Latch Switch Signal Circuit
DTC B153A 08: Liftgate Latch Switch Signal Circuit Signal Invalid
DTC B153B 02: Liftgate Open Switch Signal Circuit Short to Ground
DTC B153B 05: Liftgate Open Switch Signal Circuit Open
DTC B153E 02: Liftgate Position Sensor Signal Circuit Short to Ground
DTC B153E 05: Liftgate Position Sensor Signal Circuit Short to Battery or Open
DTC B153E 08: Liftgate Position Sensor Signal Circuit Signal Invalid
This is not a job for a diy'er or vehicle owner .
11/3/2018 2:09:44 PM •
Cadillac SRX...
•
Answered
on Nov 03, 2018
•
645 views
Not finding what you are looking for?