20 Most Recent 2009 Buick Enclave CXL Questions & Answers

Usually, you would have 2 problems here. First, the key. The key should come out, unless it has the wrong key in it, in the which case you will need a locksmith. If it has the right key in it, try to turn the steering wheel right or left and try to take the key out at the same time. GM cars have a locking wheel, that can bind up the key switch if the wheel is jammed. You might ask around for an older person, because others will have had the same problem. The starting issue has a whole long list of things to do. Try to resolve the key first. God bless your efforts.

Need to use a scanner to see if there are any codes pertaining to the transmission. https://www.acadiaforum.net/threads/2010-wont-shift-out-of-first-at-cold-start.13432/

Checked code's where ? Full system scan or just OBD2 . What type scan tool ? Or is it just code reader ?

Hello. It seems either your a/c control panel is defective/malfunctioning and/or a freon condition; either too much or too little. Good luck and keep me informed; if you want to.

You can do it yourself. Apparently it is called a Power Window Reset and the instructions are in the manual. https://www.enclaveforum.net/threads/auto-up-windows.8058/ videos here as well https://www.google.com/search?q=buick+enclave+power+window+motor+programming ..

Yes,you should be able to move the blend door with your fingers

Yes there is a air temperature control door and that is moved by a small electric that can hold its position according to the temperature setting you desired.

Actually, a new rear wiper module/motor is probably needed. The logic controller is on the motor so the entire motor has to be replaced. I believe the switch is on the center console and I think you will need to remove the outer trim to get at the switch. It may be a switch that just snaps in, so I would get a look at a new one before digging into the job.

What year ? The relay's are located in the under hood fuse box . With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the underhood fuse block. Refer to Wiper/Washer Schematics. Which wipers are you talking about ? Front or rear . Rear wiper fuse is in the I/P instrument panel fuse box . Fuse Block - I/P Under the lower right side of the instrument panel

bad connection at the circuit board connector

should be a legend on fuse cover, or refer to owners manual

Yes that is true.

If you're finding it difficult to service/repair your car, get one of those online manuals. You'll not have to wait for others to answer, or rely on mechanics and all. Plus i know a website that has very good manuals online, without expiry i.e. for lifetime. www.reliable-store.com

I recently experienced the same issue. The problem was the pressurized fuel pump. Apparently this is a know issue with the Enclave. When I took my 2013 Enclave to a Buick dealer they replaced pressurized fuel pump ($450 labor and parts) without charging me.

EITHER YOUR BATTERY IS LOW IN CHARGE OR YOU NEED A NEW BATTERY CHECK BATTERY CONECTERS AND CABLES ALL YOUR CONECTION MUST BE CLEAN.ONE MORE THING CHECK YOUR STARTER. GOOD LUCK.

Check your owners manual.