2006 BMW X3 2.0d - Answered Questions & Fixed issues
Catalytic converter location
Under car inline with Exhaust system pipe work will have a wire attached which needs unplugging the Lamda sensor.
I have a 2006 BMW
almost sounds like the air tubing came lose behind or under the dash. reconnect the hoses.
My diesel engine bmw x3 is smoke too much
If it is black sooty smoke injectors are putting to much fuel into the cylinders so they may need to be tested
Whitish grey smoke could be extra oil burning due to busted cylinder rings or head gasket allowing coolant into cylinder
I want to know how to check my bmw x3 v6
I would suggest taking it to a shop... however if you have the means there is a plug on the transmission that you remove and if fluid drips out it is good if no fluid then add. There is no dipstick
BMW X3 2.0d Loss of power
You might have transmission problem. It could be low fluid level or could be an internal transmission failure. I suggest you to have the fluid level checked for quality. Another thing you can try to reset your transmission.
BMW transmission would help you to know about the transmission better.
11/10/2014 7:35:17 AM •
BMW X3 Cars &...
•
Answered
on Nov 10, 2014
•
4,152 views
I have BMW X3 DM
This will depend on the color of the smoke. A bluish color would indicate that you are burning oil. There may be bad oil seals somewhere in the engine. A common place where oil comes in is in the spark plug. Inspect the plugs for oil. Each of the holes for the plugs has rubber seals which prevents oil from entering. Have the plugs replaced if it has been fouled and the rings.
If it is a white color, it is antifreeze or radiator fluid that you are burning. Check the head gasket. If it is a black colored smoke, you are running rich. Try cleaning the intake with a electrical cleaner spray to clean out the MAF sensor. Check also if your O2 sensor has been disconnected.
At times the engine light does not turn on but there are cases that an error may have been detected in the past. It would also be a good idea to use a scanner to retrieve errors. Some shops would let you borrow one. If there is an error it would help us determine the problem accurately.
Bmw x3 2005 headlamp bulb replacement
The last post is correct, but I also have a few tips and pictures.
1. Open hood.
2. Use a small flat screwdriver to CAREFULLY pry open cap leading to the headlight. Start directly underneath the tab that says "V2." Be careful not to break the tabs! -- to do this simply push the small screwdriver under the, as you push it in, you will hear the clip release. The cap will pop and remove very easily after that.
3. Pull out wires, unplug burned out bulb - this clips in with what I can see is a spring clip. I reccomend using a cloth when removing and replacing the bulb. This will protect your hand if the bulb breaks by accident. Also some halogen bulbs will pop/break if your hands leave oily residue on the bulb. When the bulb heats, the oil heats too and can break the bulb.
8/31/2011 3:44:53 PM •
BMW X3 Cars &...
•
Answered
on Aug 31, 2011
•
11,219 views
When I press my remote two times to unlock all my
sounds like a short between the mirror control wire and the passenger side unlock wire, probably the wires have rubbed trough the insulation, you have to locate the wires and put some insulation tape on the spot they have rubbed trough,
Not finding what you are looking for?