Top 20
1996 BMW 328i Questions & Answers
Fuse box location
engine bay
or driver side pannel but some in the passenger side glove box comparrment
5/24/2016 4:55:46 PM •
1996 BMW 328i
•
63 views • 0 helpful votes
Camshaft variable timing
Repair manual, try filepeep.com, or manualslib.com or local library or you will probably want one later, so most Autoparts stores carry them.
3/20/2015 11:48:44 PM •
1996 BMW 328i
•
169 views • 0 helpful votes
What is the radio unlock code for a 1996 BMW 328i?
If you cannot find the code written on something in the glove box, you will have to remove the radio. Once removed, you will need the serial number off of the radio chassis. You can call BMW with this number and they will give you the code.
Hope this helps!
-Scott
europartsplus.com
8/19/2014 10:32:56 AM •
1996 BMW 328i
•
518 views • 0 helpful votes
What is the unlock code for a 1996 BMW 328i radio
If you cannot find the code written on something in the glove box, you will have to remove the radio. Once removed, you will need the serial number off of the radio chassis. You can call BMW with this number and they will give you the code.
Hope this helps!
-Scott
europartsplus.com
8/19/2014 10:40:53 AM •
1996 BMW 328i
•
422 views • 0 helpful votes
How i can disassemble the front bumper of bmw e46
Never done one but all i would do is first have a cup of tea - look at it then decide where the fixing bolts are then undo the fixing bolts and the fog light connections if fitted and any plastic trim splash guards under the car and off it comes .Then go to the local cafe for a coffee
9/2/2014 6:26:06 AM •
1996 BMW 328i
•
161 views • 1 helpful votes
How do I remove standard transmission from 1995 ford f150 ?
disconnect the battery cable then remove the drive shaft from the transmission then remove all wire and cables, then support the engine and take out all the bolts from around the toque converter then from around the transmission,then lower the transmission
6/27/2014 4:02:26 AM •
1996 BMW 328i
•
194 views • 1 helpful votes
P0340 fault code
Assuming you have a 1996 328i convertible based on your photo as there were no US 96 328is.
It is located at the left front end of the the engine cylinder head under the plastic cover behind the VANOS solenoid next to the top of the oil filter housing. In addition to the new sensor, you will need new metal o-rings for the VANOS line, a new rubber o-ring for the camshaft sensor and perhaps a new socket head cap screw if you round out the internal hex trying to loosen this Loctited screw.
See Figures 1 & 3 at the following Pelican Parts link.
http://www.pelicanparts.com/bmw/techarticles/101-Projects-14-Cam-Sensor/101-Projects-14-Cam-Sensor.htm
5/25/2014 7:15:52 PM •
1996 BMW 328i
•
459 views • 0 helpful votes
Not finding what you are looking for?