2008 BMW 320i Automatic - Answered Questions & Fixed issues

Could be your driver door lock mechanism that is going bad , since the other door are working, it cannot be the fob. I would try to change the driver side door latch mechanism.

you can access it from inside the trunk. There is a plastic panel covering the back of the lights and a couple nuts that hold on the panels. Remove them and you will have access to the bulbs.

jai bmw 320i 2007 quil a change la polarite de la batteria de ignition il ne demarre plus et montre le cod de cle p 1061 qui je dois faire

Please try another bulb before you go for something else. Many times happened to me even the new bulb not working. Advice: just remove the good bulb of brake light you have on driver's side and try it on the passenger side. If it works,surely another bulb. If not,ask for an Electrician to help.

Spark comes from the coils. Which gets a signal from the computer which comes from the cam and crank sensors. If the cam is not turning or a part is broken and the computer won't send a signal to the coils it wont fire. Throttle is for fuel and air mix.

I can't find it on a quick Google search, but put your VIN into this website and it'll tell you: https://decoder.bvzine.com/

check the basics first. Fuel pressure - there is a shrader (sp?) valve on the fuel rail on the engine where you can check that. Check if there is spark - pull on of the coils and put in a spark plug and crank. It can also be the ignition switch but check the two things above and then you will know where to look for the problem

That would require a detailed procedure so its carried out properly u can get a manual for help.. I keep getting those for my vehicles too.. I know a lot of websites and which one is best for what type of vehicle. and which websites have customer care service etc

hi If the heater are not working then first of all check your coolant (water) level. These are the common problem on BMW Thanks

All kinds of repair manuals are available here.Have a look of this may be you will get something useful. bmw

check coils and spark plugs

5ltr + 2pints= 6ltrs of engine oil

Maybe size of wheels?

I have noticed when the oil is changed, there is a splash/skid plate near the drain plug and old oil may collect on top of that plate, then drip down later. Worth a look.

are the pluged in correctly? if yes then coil pack is faulty. they are common problem on bmw

try looking on that website for infos. http://www.obd-codes.com/trouble_codes/ hope to help.

only thing I found . go to that link http://www.obd-codes.com/p0491 hope to help you.

there is a valet switch that can lock the tailgate , just check for it in the passenger glove box . make sure it's not activated or disconnected.

First thing you need to do is to have the car scanned with a engine malfunction light scanner . then you'll get a engine trouble code. even if the check engine light shuts off for sure you'll get a pending code witch is a code that was seen but could be not present at the time you scan the car. depending on what is the code then search on google for bmw engine trouble code list and repair procedures. to find out what codes meens go to that link http://www.obd-codes.com/trouble_codes/bmw/.

Sometimes the computer takes over the car. Have you tried to reset, by disconnecting the negative cable on the battery for a few minutes to reset. That doesn't always work but, worth a try. Some sensors might also be missing from the changed tranny. Hope this helps.