20 Most Recent 2013 Ford Focus - Page 7 Questions & Answers

Clicking means that solenoid itself works fine. However it doesn't open which means that link (bolt) from solenoid to lock mechanism is broken.

Here it is. Picture location horn 2014 ford focus Google Search

Can you provide the actual code? The codes do not tell what part to replace--they only indicate a problem the computer is having. The problem must be further diagnosed for proper repair.

if the place where you had the oil changed used a oil flush pressure system they could of damaged the seal as they not supposed to have that amount of pressure on them, this would damage all or most of the oil seals. a good oil change is were they dont use one of these systems they cause more problems over time. if you do an oil change its best to do it your self or at a garage you trust. and ask them to add flush cleaner this is a substance you add to the oil and run for 15 min in the engine and then do the oil change, you dont always need to use a flush only if there is a build up of oil carbon in the engine. some build up is normal but if you change the oil regular you don't need to flush as its only old oil that needs changing and flushing. hope this helps

How To Install Replace Front Door Panel 2000 07 Ford Focus with Manual...

You need to take belt off and loosen the bolt,then you can align the holes up.Is there some type of sealant between the water pump and housing,if so,then it will be stuck,you may have to remove water pump and reinstall,if you move it,it may cause it to leak.Check this video out. How to Replace the Water Pump on 2001 Ford Focus ZX3

Check this video out,will send 2 of them. 2007 Ford Focus power steering pump Here's the other one. 2007 Ford Focus 2 0 Power Steering Replacement . "IMPORTANT: To improve longevity of system, manufacturer recommends installing in-line filter to catch excess contamination, part number 70702"

Sounds like an interlock solenoid is out of adjustment. Pushing the clutch is suppose to allow a solenoid to hit a striker and send an electric signal to release the ignition switch. Just to be careful with the car rolling if the clutch is depressed.

Yes they are relearned within a or days of mixed freeway, city and stop and go traffic driving.

Hey! That look you problems with pulleys,holding the serpentine belt Get oils spray into it,than you can see.Make the prove one at the time. Start the motor and see squishing noisy goes away Even do it in the AC motor pulley Note:Do not forget change the serpentine belt

1. Check the radiator cap.
2. Check the reserve tank, whether water level is maintained or getting filled. If it's getting filled, there should be a leak in the radiator or gasket

98 lb-ft

Could be a number of things go to autozone or similar and have vehicle scanned for codes this is free