2015 Ford F-250 Super Duty - Answered Questions & Fixed issues
Where is the fuse for the cigarette lighter found
I went on to web typed in the search box pdf 2015 SUPER DUTY owners manual and up popped the manual with where fuse boxes locations are , one in the engine compartment ( power distribution box) on page223 and on page 228 is the passenger compartment fuse box with what all fuses do but there was no cigarette lighter fuse unless it in one of the Auxillery fuses . hope this has helped.
How to remove speed limiter
You can't. It is built into the ECM. But there are places that can remove the programming. I don't know of them, I just fix cars and trucks to specs.
Front lights dont turn on. on a 2000 ford f250 super duty disel
I would look for a problem with the headlamp switch. Also it could be in the multipurpose switch which is part of the turn signal switch I have seen both problems. You will need a test light that will light when you probe 12 volt wire. Follow the 12 volts from the fuse box, some trucks fuse the headlamps, so make sure they are all aright. Follow it to the head lamp switch to make sure it has current and if it does, probe the wires that are connected to the multipurpose switch. Make sure that the headlamps have a good ground and that they are both not bad.
2002 F250 V10 with trouble code P0720
The OSS or Output Shaft Speed Sensor is located in the top of the tail shaft housing of the transmission just before the driveshaft, it is an 8mm bolt that holds it in, very tight place to be but can be change fairly easy.
1999. Why is A/C air flow poor?
air flow from and air conditioner is dependent on the condition of the heater blower fan
so check that the blower fan is operating at all fan speed settings
next if you live or use the vehicle in dusty conditions , the dust will build up on the evaporator fins ( condensate water and dust = mud and gunk) and blocked evaporator fins ( this will result in reduced ac operation as well
the dust is not always from out side air through a cabin filter ( may be blocked) but from dirt that is introduced into the cab from dirt on the foot wear
Were abouts is the front and rear axle rating tag
THERE IS A TAG EITHER ON THE DRIVERS DOOR OR THE DOOR PILLAR THAT WILL SAY WHAT THE RATING IS IF THERE NOT THERE CALL YOUR FORD DEALER PARTS DEPARTMENT AND GIVE THEM THE VIN # AND THEY CAN TELL YOU WHAT IT IS
The code came up p-0743 how do i fix this
You replaced the O2 sensor and the other codes popped up ?I would clear the codes and see how many return. Often times the problem is not the sensor but rather something in the engine performance.
2002 F250 V10 need solutions for P0460 trouble code
The Code P0460 means you are running Rich. This is being picked up by the O2 sensors.What happens is an air leak in the intake side of the engine(any seam) of the engine is measured and this added airflow makes the top part of the engine lean. Automatically the sensors start dumping more gas to maintain fuel ratio. Because of this , the exhaust gas spikes from the excess fuel.You need to find the air leak. Sometimes using a spray bottle of water around seams and Vacuum lines and solenoids will change the idle RPM. The running engine will draw in the water and react.If this does not work, check the fuel pressure at the test tap. Some tools can be borrowed from Autozone,Advance, or Oreilys. If you have high pressure, this could be the result of the lean reading or a defective fuel pressure regulator.I hope my solution helps. At this point, we Experts can not see what other Experts have recommended. So there is a good chance some of this has already been suggested.
Not finding what you are looking for?