20 Most Recent 2014 Hyundai Elantra Questions & Answers

Question edited for clarity. Question moved to sub category. The P2159 diagnostic trouble code is most commonly fixed by replacing the vehicle speed sensor. Keep in mind that ABS components, other trouble codes, and aftermarket tires may be responsible for this code being stored by the PCM. Take time and complete a thorough diagnosis before replacing the vehicle speed sensor.

P2159 OBD-II Trouble Code: Vehicle Speed Sensor B Range ...

Videos as well https://www.google.com/search?q=2014+Hyundai+Elantra.+How+to+fix+P2159 ..

Mine shut down after 5 minutes if non of the accessories are in use.

The chirp comes from the alarm system itself. it may be a electrical short in the alarm system, or a damage in the alarm itself. u need an alarm shop or a good tech. wish I was there.

Is it possible that your blower motor is going out and drawing too many amps and burning out the control module? Or maybe a poor ground or bad connection?

the fob will not start the car unless the button is being pushed so it is logical that the second fob that your are using that is doing the job as to distance from the car talk with a service technician but the distance will be around 30 ft max if the fob will not unlock the doors until you get close then that is an indication of the range of the fib

rock wheel left and right with key in ignition until it goes in.

You can try re-programming each Tire pressure monitor (TPM) using the procedure in the owners manual but I doubt that will fix it. The most likely problem is a faulty TPM which is no longer functioning and will need to be replaced.

I would bet it has step by step in the owners manual.

Hi, Please make sure you steer your steering wheel while you're putting your key to start. I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482

Take it to the dealer,, any salesman should be able to explain it, Read the manual, it is in there some where,, BT- Audio Phone must be in locate mode.. radio has a Setup mode where you have to pick the pass code ( or use the one set ) Check the manual and i am sure that you can work it out,

Question edited for clarity, correct spelling of model. Question moved to model category. It could be so many things. Find a local auto-electrician, a professional grade scan tool computer will diagnose all the electronics computers, modules and sensors in 30 minutes. https://www.google.com/search?q=auto+electrician+near+me ..

some cars the dash has autodimmer a sun sensor on the dash some can be disabled , so read the users guide to do that. most cars, we can disable the out dim in the free users guide, search word DIM. bingo,? see on,off ,up ,down or auto?> find the top of dash sun sensor shine a very bright light there, and dash DIM goes full bright, if yes, bingo see the users guide in the glove box yet page 5-42 is your answer see the words obstructs either sensor bingo it is in your manual this. https://www.carmanualsonline.info/hyundai-elantra-2022-owners-manual/?srch=dim

This usually indicates a problem with the transmission control module (TCM). You should have a qualified mechanic inspect and diagnose the problem, as it could be something as minor as a faulty TCM or something more serious such as a transmission failure. Replacement of the TCM or other components may be necessary to fix the issue.

My 2005'hyundia Tuscan no ac no heater no defrost new blower motor and new resister still nothing