20 Most Recent 2005 Toyota RAV4 Questions & Answers

no problem told , no evidence, just wild HUNT, well most cars have no such module , newer cars he bCM does it all but I will look for you but NO COUNTRY TOLD IF IN CANADA SAY SO , MY MANUAL DOES USA AND CANADA ONLY AND THEY ARE NOT THE SAME AT ALL BUY THE SERVICE MANUAL FIRST. AND READ, I MUST PAY TOO... OK LOOKED, LOCATION DRAWING PAGE, X7 , ZERO DLR. OLD CARS HAD THIS DLR MODULE THAT LIKED TO BURN UP PINS ON NEWER CARS WITH BCM THE MAKER OF MOST CARS DO DRL BY SOFTWARE(BCM FIRMWARE) TO RUN LAMPS OR MODULATE FRONT LAMPS AT SAY 50% FOR DRL LAWS UP IN CANADA. here is the answer and schematic for DRL , if is there not required in USA at all there is no module it is ecu controlled and with lots of relays. and programming, of ecu to do all that, if opted day 1 new. https://www.trav4.net/drl_relay_circuit-898.html

Your vehicle, like nearly all modern cars and trucks for consumers - should have a standard, 12 Volt Negative Ground electrical system.

Air intake is measured by Mass Air Flow sensor located midway between air intake source and intake manifold. https://www.6ya.com/callphilipforhelp

the jets have a non return valve inside that gets stuck change the jet and that should fix the prob

Have the codes read for the engine/transmission. Certain engine codes will turn on the VSC and Trac lights.

u have to replace the gear box

They are the fog lights. Some would call them driving lights if they don't have a proper fog lamp in there. .

manual or automatic, if manual your pressure plate/ disk may have gone

It is 10 years old. The little battery could (probably) be bad.

Most vehicles today have 12 volt negative ground and yours does.

The one on the tensioner pulley is it.

Not wired correctly or fader needs setting!

Try this... Turn the key to the 'on' position. Press the trip button meter until it displays the "Trip A" odometer. Turn they key to the off position. Then while holding the trip meter down, turn the key to the 'on' position. 4 blinking dashes will display and they will count down. When the last dash disappears 000000 is displayed to indicate the maintenance counter has been reset.

Insert the key into the ignition. Press and hold the trip meter reset button. Turn the engine switch to the "on" position. Hold the trip meter reset button until the trip meter displays "000000." The maintenance light is reset.