20 Most Recent 2014 Volkswagen GTI - Page 4 Questions & Answers

Check your Air Mass Sensor. Take great care as they are easy to break it is just a fine wire.

There is a cleaner available at an autoparts shop.

If you are not sure how. Go to the library and get the Bentley shop manual to explain the process in detail.

TAKE GREAT CARE WITH THE SENSOR.

Duralast/Clutch Set Part Number: NU31668 Warranty: Limited Lifetime Application: With 6 speed transmission9 1/2" disc outside diameter

Notes: Spline inside diameter 1 5/16". Spline count 23. Add More Items to Compare Add More Items to Compare Price: $316.99 STORE PICK UP SPECIAL ORDER SHIP TO HOME AVAILABLEADD TO CART Duralast/Clutch Set Part Number: NU31620FW Warranty: Limited Lifetime Application: With 5 speed transmission8 7/8" disc outside diameter

Notes: Flywheel Included. Spline inside diameter 7/8". Spline count 28.

You'll have to get your hand in there around the hood latch, and lever the latch over towards the driver's side. The lever that the cable hooks to. Sometimes you have to pull the grill off to get your hand in there. And sometimes you can lay under the car and reach your arm up to get to the latch. You may have to move something aside to get your hand up there. Use a screwdriver or something to push the lever over to open the hood. Good luck.

Sounds like your alternator is not working, if you can get the engine running and have access to a volt meter check the voltage on the battery terminals, With the engine running you should see in excess of 13V

The best thing to do is to take it to the local Autozone (auto parts store) and use there OBD II scanner (for free) and hook it up underneath the drivers side steering wheel and obtain the error codes it will give you then look at the back of a Haynes repair book and match that code up to the number in the book to pinpoint the exact part that is failing you otherwise you will replace parts that are not needed to be replaced costing you more money then you need to spend. The EGR valve is located near the center of motor (see pic below)

if you ever **** up water and you get it shut down in time the only way to get the water out is to tear the negine compleatly down and clean everything cause if you dont wait long enough you risk ####in up your engine and it could take up to a couple months if you wait :thumbdown