20 Most Recent 2015 Chrysler 200 - Page 2 Questions & Answers

engine size? year of car?

James, I would check the valve cover gaskets first but to cut down on the frustration go to auto zone or such and get a bottle of dye that is made to do this and a blacklight follow bottle directions it is UV sensitive and will pin point your leak. Not expensive either. Hope this helps.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Is the car still drivaeble? reset the codes using a tool available at your local auto parts retailer. If they return, seek a good mechanic. If not, okay.

Partially filled or clogged heater core. Check fluids first.

In this model, the TCM is often located near the transmission, mounted on or near the transmission housing. However, exact locations can vary slightly depending on the specific vehicle configuration. It's advisable to consult the vehicle's service manual or a qualified mechanic for precise information on locating the TCM in your specific vehicle.

troubleshoot this further: Check Transmission Fluid: The first step is to inspect the transmission fluid. Low or contaminated fluid can lead to poor shifting performance. Ensure the fluid levels are adequate and replace it if necessary. Throttle Position Sensors and Shift Solenoids: Misaligned throttle position sensors or malfunctioning shift solenoids could be causing the gear shifting problems. These components play a crucial role in proper gear changes. A professional diagnosis is recommended. It is not unusal for a defective solenoid to render this effect. Transmission Control Module (TCM): The TCM manages the transmission's operation, including gear shifting. If it's malfunctioning, it can lead to incorrect or no gear shifts. Consider checking or replacing the TCM. Shift Linkage or Cable Issues: Damaged or worn shift linkage or cables can also cause gear shifting problems. These components connect the gear shift lever to the transmission. Inspect and replace any damaged parts. Remember that diagnosing transmission issues usually requires professional expertise.

Spare wheels are no longer required due to the torque setting to remove a wheel and the use of sealants that inflate a flat tyre for a limited period of time allowing one to get the tyre repaired/replaced. Space saving comes straight to mind.

That is called the Exhaust Manifold. One side is attached to the side of the engine, and the other side is attached to the end of the Catalytic Converter. If the car is horrendously loud, someone has stolen it. If you can see it under the van, the gaskets just need replacing or the bolts tightening. The Cat often has a flex pipe which can split, in which case it needs replacing.

When you say the "oil light," do you mean the light that says "Change oil" or are you seeing the red light that indicates low oil pressure? If you're seeing that red light, that likely means you have low oil pressure and should stop driving immediately, until the problem is diagnosed and repaired. It's also possible to see the oil pressure light on when there's no issue with oil pressure, if the oil pressure sender has failed or there's a connection problem.If the oil light you're referring to is the "change oil" light, you will need to manually reset it for it to disappear. Here's how (from Chrysler):1. Turn the ignition switch to the ON/RUN position (do not start the engine).2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.NOTE: If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps.