20 Most Recent 2010 Subaru Tribeca - Page 5 Questions & Answers


If power windows, the usual reason is that the winder motor brushes have worn out. Second reason is that power is not being applied from the switch. Time for someone to check with a voltmeter.

Subaru Cars &... | Answered on Jul 21, 2019


Try this I hope this helps. Take care.
c9070206-e0de-4ae4-9c41-fb607b872a87-2dwrtwwc4fkuw0vpkoxd4ivp-1-0.gif

Subaru Cars &... | Answered on Jul 19, 2019


I'd suspect the battery right off, disconnect the battery overnight and if it's dead in the morning or even just low replace it, Do this even if the battery tested good or is new. If you satisfied that the battery is good feel the starter solenoid after it sat long enough for the engine to cool off if it's warm the hold in coil in the solenoid is shorted, not uncommon. I hope this helps. Take care.

Subaru Cars &... | Answered on Jul 14, 2019


Possible that one of the brake calipers may be sticking causing a drag on one wheel. When the abs light comes on the engine goes into a limp mode which will cause the car to run with less power.

Subaru Cars &... | Answered on Jul 10, 2019


Get the trouble codes read. That's always the starting point when a warning light comes on.

Subaru Cars &... | Answered on Jun 27, 2019


Could be a lifter that just hasn't gotten oil at the start. If it is a small ticking, it's not a big problem. Often using an oil flush just before an oil change can loosen up sticky lifters. I have also tried a few ounces of transmission fluid in the oil and that has worked with my lifter noise (2004 Suburban).

Subaru Cars &... | Answered on Jun 27, 2019


Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Subaru Cars &... | Answered on Jun 23, 2019


Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Subaru Cars &... | Answered on Jun 23, 2019


The automotive diagnostic plug is on the left of the clutch pedal under the dash.

Subaru Cars &... | Answered on Jun 14, 2019


Check for broken wire on ignition tumbler.

Subaru Cars &... | Answered on Jun 09, 2019


The service and repair manual with diagram will provide you step by step to locate and fix the problem easily and you will get the manual from the given link Home Toolsnyou https://toolsnyou.com

Subaru Cars &... | Answered on Jun 08, 2019


check and test fuse-:bulb -socket-switch-connections - wiring

Subaru Cars &... | Answered on Jun 06, 2019


Once the freeplay is set it should not alter, the driven plate linings may have come loose or the pressure plate may have a broken spring. If so replace as a kit including the throw out bearing and spigot hearing.

Subaru Cars &... | Answered on Jun 03, 2019

Not finding what you are looking for?
2010 Subaru Tribeca Logo

10 questions posted

Ask a Question

Usually answered in minutes!

Top Subaru Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Tribeca Subaru

  • Tribeca Subaru

Most Popular Question

lights stay key out

  • Cars & Trucks
Loading...