20 Most Recent 2010 Subaru Forester Questions & Answers

A common problem is the button switches on key fob circuit board have broken their soldering point. If you have (or know someone technical with) a FINE point soldering iron, the switches can be resoldered. This may not fix the your problem. If not, you need a new fob (try Amazon.com) Read up your owners manual on the procedure to reprogram the security system for new fobs. The process is tedious and usually takes some effort to the procedure to work.

whats a casual problem if and when brake boosters fail brake pedal is like stepping on a brick if you dont trust mechanic get second opinion but sounds like booster failing or vacuum valve failure

indicates that it is the booster or second ,a faulty brake master cylinder boosters can be repaired for considerably less than that or get a good unit from the wreckers /junk yards get a second opinion from an accredited brake specialist shop

consider this when at the stop lights , you will have your foot on the brake as it will still be in drive or in gear and you don't want the car to move a simple test is to apply the hand brake to stop the car and don't touch the foot brake if it idles ok but cuts out when you apply the foot brake , replace the brake booster as it has a vacuum leak that is causing the problem you can do this test in the garage by starting in neutral and allowing the engine to idle , then apply the foot brake iof it dies it is the booster

Sounds like a loose wire connection

almost any automotive parts store has them

images for 2001 Subaru Forester wiring

Subaru dropped the 'virgin switch' on top of the steering column, not sure when. If the rotating light switch at the end of the turn signal stalk on the column is fully rotated to OFF - and the running lights are still on, you may need a dealer or mechanic to look for a bad relay or possibly a short somewhere. Sometimes wires go bad in the boot to the hatch - leading to odd electrical problems. Certain type of dual element bulbs can cause issues too. Double check that none of the light assemblies have collected water.

Have you checked the wheel bearing?

there is a short between the headlights and whatever is on 16 fuse

Yes, this can damage the engine, do not run the vehicle. You need to drain the tank completely, as well as drain the lines and may even change the fuel filter.

The lights will illuminate for two seconds when the ignition is turned to the on position The lights will turn on and then off when the engine is started The lights may come on and stay lit after the engine has started then turns off when the vehicle reaches about 25 mph / 40 kph The lights may come on during driving but then turn immediately off. - - However, do not hesitate having the computer codes and system checked by your Subaru specialist. Good luck.

Most autoparts stores carry them or try filepeep.com or manualslib.com

bad head lights bulb grownd or power

Although I have never encountered this issue on my own 2010 Forester, I would say that this may be a fuel system problem with a sensor or component. The place to resolve this is at a Subaru service department.