2010 Mazda Tribute - Answered Questions & Fixed issues
Loud whining noise especially on exceleration in 2010 Mazda Tribute
A loud whining noise on acceleration in a 2010 Mazda Tribute could be a sign of a few different issues. Here are some potential causes:
- Power steering pump: A whining noise can be an indication of a failing power steering pump. The noise may increase when the steering wheel is turned.
- Alternator: If the whining noise increases with engine speed, the alternator may be failing. This is because the alternator is responsible for charging the battery and powering the car's electrical system.
- Transmission: A whining noise during acceleration could also be a sign of transmission issues, such as low transmission fluid levels, worn bearings, or a damaged gear.
- Differential: A whining noise that increases with speed could also be a sign of a failing differential. This is the part of the car that transfers power from the engine to the wheels.
It's important to have a professional mechanic diagnose and fix the issue to prevent further damage to your vehicle.
2/23/2023 6:32:28 AM •
2010 Mazda...
•
Answered
on Feb 23, 2023
•
179 views
I have a 2010 Mazda Tribute, 2.3 Liter engine on
find the real owner and take it and him to a dealer. if defective the battery will be replaced under the bumper to bumper warranty with a correct one. also the replacement will be done correctly so that the electrical system still works after replacement.
8/31/2011 10:07:47 AM •
2010 Mazda...
•
Answered
on Aug 31, 2011
•
164 views
Battery keeps draining on 2010
Had a truck that kept killing battery and we unplugged the air conditioner control panel and no more dead battery. Don't know if will be helpful but worth a try.
6/27/2011 1:34:50 PM •
2010 Mazda...
•
Answered
on Jun 27, 2011
•
1,180 views
Why would the starter motor
it can happen on any new machine but if car was not abused in any way should be covered under warranty
3/29/2011 10:30:18 PM •
2010 Mazda...
•
Answered
on Mar 29, 2011
•
138 views
My 2008 Mazda Tribute sunroof leaks
First I'd access the Mazda dealer. If they can't identify the part or supply one, check with the aftermarket supply businesses. Best thing will be to take pictures of the part. You can also access many online sources and diagrams to identify the part and perhaps then to find it from a supplier. If all else fails I'd access the wrecking yards especially the online ones and the self service ones. This may be a part that is not just on one model or model year. Last resort might be to find someone who can 3-D or otherwise print a new one for you. If it looks like a rather simple item you may be even able to make one yourself. What the item is made of may not be the material it has to be made of.
Madza 2002 ES tribute V6
check and test brake light switch--shift interlock---any codes --damaged or disconnected trans linkage/cable
Mazda tribute has no spark!what could be the cause?
How do you know there's no spark?
If engine cranks but won't start, that doesn't necessarily mean a no-spark situation. Try cranking the engine, then remove a spark plug and see if it's wet. If no, the problem is no fuel. If the fuel gauge is near empty, try adding a gallon of gas to the tank. If there's still no fuel to the engine, and the most likely reasons are 1) a clogged fuel filter or 2) the fuel pump relay has failed (fairly unlikely) or 3) the fuel pump itself has failed. If you haven't changed the filter for a while, might as well change it -- they're not very expensive. If that doesn't work, find the fuel pump relay (check owner's manual or online) and see if you can replace it temporarily with a non-essential relay from a different circuit.
What is the size of the brake caliper bolt on a 2004 mazds tribute
i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
How do you adjust the
On a 2006 Mazda Tribute which everyone tells me is a Ford Escape, in the cab, at the parking brake lever, remove the boot or decorative cover on the parking brake handle. The brake adjustment is a self-locking nut on the threaded end of the parking brake cable that connects to the left and right parking brake cables underneath the car.
The only adjustment possible is right there at the handle after you remove the boot that covers the parking brake handle in the center console. If the brake has been allowed to get loose, the cable may very well have come off the cable guide on the parking brake handle and there will be no braking and the cable may very well be cut or partially cut by the handle. With some straight screwdrivers push the cable into its guide and then adjust the parking brake.
But, underneath, there is no adjustment whatever possible for a 2006 Mazda Tribute.
On a 1991 F-250, yes, but not here. Don't get dirty for nothing. This is the easiest brake to adjust since the old screw handles.
7/17/2018 8:44:21 PM •
Mazda Tribute...
•
Answered
on Jul 17, 2018
•
1,955 views
I have a 2010 Masda tribut reae hatch not releasing
The best solution you'll get from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts i nfo, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc
The rear glass window hinge
Hi. Thanks for your question. For any assistance related to Mazda rear glass window hinge you can visit
https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!
Not finding what you are looking for?