20 Most Recent 2010 Mazda MAZDA6 Questions & Answers

Faulty connection of wire to bulb or bulb socket to body of car.

switch shorted

Couldn't find the exact on point video but there are a couple that should be helpful. First a generic: There is also a 2 parter for the mazda 6 but it is focused on the door actuator

I changed a headlight on my Gen1 (2003-08) Mazda6 and had to remove the bumper cover to do it. It wasn't that hard, but it required me to put the front end up on jack stands and remove the front wheels to get to all the snap-plugs in the fender well. There are also several screws on top and underneath.

Could be the power steering pump is bad.

Try cleaning the contact blots sometimes dirt makes them not make contact

Hi you need to have a diagnosis on why the engine light was on in the first place. By disconnecting the power source to the onboard computers on connection they have probably come up with a mismatch due to something being outside it's set tolerance. The reason it stops when clutch is depressed is you are removing the load from the engine. A fault code reader needs to be plugged into your vehicle, hopefully the codes will still be there as sometimes they might be removed when power is disconnected. Good luck

Possible causes Intake air leaks Faulty front heated oxygen sensor Ignition misfiring Faulty fuel injectors Incorrect fuel pressure Lack of fuel Faulty Mass Air Flow (MAF) sensor Incorrect Positive Crankcase Ventilation (PCV) hose connection Read more: https://www.autocodes.com/p2187_mazda.html

sometimes by disconncectin one battery cable the ground,, - neg then spepping on the brake peddle to assure the capacitors inthe system are drained dowm reconect the cable and retry to start.

no resetting the ecm is with a scan tool but you can use the scan tool to find the failed sensor preventing it from starting