2011 Lexus ES 350 - Answered Questions & Fixed issues

Question edited for clarity. Question moved to model category. It should be the same as the IS350. Many of the search answers are showing Camshaft as opposed to Crankshaft. https://www.google.com/search?q=lexus+es+350+crankshaft+position+sensor+location ..

Yes the windows are controlled via a computer module, so it can be scanned to see what is going on by the dealer service dept.

After removing all door-accessories and armrest, you may be able to pull and lift the panel out.

Use a D C tester and check for voltage it could be a bad lighter. if that dose not work take your voltage tester and put one lead in the lighter hole on the center and ground the other lead to the metal on the car check for voltage. You may have a bad ground.

Try inflate tires a couple of lbs. above recommended pressure. On some vehicles you have to drive for a day or 2 before it resets itself.If no luck a tps(tire pressure sensor) may be bad.

as long as it is working it is reliable but to be on the safe side it might not hurt to have a spare. you can get them at any Lexus dealership that has a parts dept. they usually cost around 100- 150 dollars

This is a NEW car, I have a 2005 ES330. Connect an ammeter to the battery. Pull the fuses one by one. The one where the amps drop, it the circuit where the parasitic draw is. May items draw power, like the radio and the ECM but one will show a big drop. You can also make sure the hood light and the trunk light is turning off, the vanity mirror as well. It may be a failing battery, but unlikely in a 2020. Surely it must still be under warranty!

scan for trouble code and go from there

have repair shop check for unplugged damaged wiring or damaged container

here's a website that has all this in formation about all this and manuals everything totally free there are many actually but I personally like few .. let me know if u need help thanks

Have seen this and replaced the electronic control on the dashboard and got the next one from the local scrap yard. But you need to make sure the servo motor inside the air box opens the flap properly first.

Edward, fuse box above drivers feet under dash. you may want to check out attached links for fog light problems. 07 Es350 Fog light relay Club Lexus Forums Lexus ES 350 fog lights fuse location Google Search Replace Fuse 2007 2012 Lexus ES350 2008 Lexus ES350 3 5L V6 Fog Lights Not Working

Probably had a factory amp that has gone out

Clean variable timing solenoid and change the oil

Here is a diagram of all the different motors. Repair Guides Firing Orders Firing Orders AutoZone com

flat rate manuals for labour charges and times to do the jobs are available from auto book shop specialists such as autolab and other. shops that handle manuals and books for cars and trucks.

Hi there:

Turn the "Engine Start Stop" switch OFF with the trip meter A reading shown.

While pressing the trip meter reset button, set the "Engine Start Stop" switch to the Ignition ON mode. Continue to press and hold the button until the trip meter displays 000000.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.

most leaks that are found by the header you most likely have a valve cover leak and that is common
they are easy to change just a few 7/16 bolts the best thing to do is when you get it off clean the
motor and valve cover very well from the old gasket the new gasket will come with two so you
might as well do both sides while you have the valve cover off paint it light blue this way you can
detect any leaks quick and use (PERMATEX BLUE) it works very well with oil and don't tighten
the bolts very tight a little more than hand tight will do

hope this helps you
good luck
bob

sounds like you need to take it back to the dealer doesnt sound at all right for 16k miles