20 Most Recent 2010 Kia Soul Questions & Answers

Maybe, I would start looking at your crank sensor readout as you try turning over very common on these models to go bad and intermittent no starts.

My friend is a part time mechanic he gets his solutions from www.reliable-store.com he gets from their every single detailed info, instructions etc. on all vehicles, and manuals like service, repairs, parts, owner's, ope rations, maintenance etc. U can get help from there there is a girl at chat she can help you

You need to replace the lamp as the low beam filament has broken. The lamp could be a double filament lamp, high & low. Or your car has separate lamps for each beam. Either way replace lamp.

Follow the top radiator hose to the engine.

may be pistons are frozen.

on the end of the armrest should have a cap or a zipper and inside is the screw to un do the arm

Have The battery and the charging system tested, my guess is the battery is most likely weak.

Had similar problem as gas would not go in my vehicle. I had a blockage in the filer neck

have the low beam circuit on the light switch tested

this indicates a faulty throw out bearing could be dry or in the process of failing completely A service tip here is as the transmission has to be removed for the replacement bearing to be fitted , it is a good idea to invest in a clutch kit and throw out bearing simply because 50% of the cost is the labor to remove and replace the transmission and if the bearing is bad , the clutch and pressure plate will soon need replacing do the job once --do it properly

Check your power steering fluid. If it is full then get some belt silicone spray and spray your belt. If you are still getting a squeak at that point listen for it to get worse and then check your water pump.

Absolutely no.

Vent door is stuck.

Caliper is sticking. Replace caliper with a new one.

Car will not start at all.

Evaporative control purge valve is defective or a vacuum leak exists.

If you take it to a place like Auto Zone, they can check your onboard diagnostics and give you what error code is causing the light. It's a free service they provide.