20 Most Recent 2010 Kia Optima Questions & Answers

Sounds like yer car is stuffed, the person who hit cha should pay for it and some. Take it to the mechanic and tell em to give you a quote to fix it and give it to the a$$hole.

Bad transmission mount.

Check to make sure that the antenna is still connected. If it is, then the tuner section of your radio has gone bad.

The engine is an interference engine. IF you have broken the timing belt, you are in for some serious repair costs. Depending on the amount of damage, a replacement engine may be cheaper than repairs.

Can you see anything on the screen or is it completely blank? Probably has an intermittent internal connection and the LCD needs to be repaired or replaced. I would think that would still covered under waranty.

Not really sure, have the dealer recheck it. I suspect it is related just don't understand how???

you need a diagnostic tool to pin point the exact location of the problem.By analizing the trouble code provided by the tool.From there check the electrical wiring for loose or disconnection, check the socket/parts for wear or replace faulty sensors. After you fix the problem disconnect battery to take out the trouble code or check engine light. good luck!!!

Instructions1Start your vehicle's engine. Turn the steering wheel the opposite direction of the bulb you need to change. If you need to change the left turn signal light bulb then you will turn the wheel as far as you can to the right. This moves the wheel out of the way so that you have access to the fender and the turn signal assembly.2Get down by the front fender of your vehicle. Use a Philips screwdriver to remove the screws from the wheel well cover. Take off the wheel well cover and set it off to the side.3Stick your hand into the wheel well and find the turn signal bulb. Turn it to the left and unscrew it from the turn signal assembly. Remove the bulb.4Take your new turn signal light bulb and screw it into place using your hand. Replace the wheel well cover and use the Philips screwdriver to secure it in place. Repeat this process for the turn signal on the other side of the vehicle.Read more: Chinasinoy

You will need the dealer to scan the system ans see what is faulty, Sorry you need a special scanner and the repair manuals to get a handle on this. I call them as i see them, sometimes the dealer is needed.