Top 20
2012 Jeep Grand Cherokee Questions & Answers
Cherokee 2012 engine does not start
where to start... see if lights turn on, if not charge battery, once battery is charge try again, if cranks then could be battery or alternator, if not could be starter, spark plugs, coilpack... after youve looked at that let me know, ill adv further.
2012 grand cherokee fuel door release button doesn't work
www.jeepgarage.org > ... > Trouble Shooting/Problems/Service
May 20, 2011 - 12 posts - 3 authors
try pressing the button and have someone else try to open the door, if it works, ... i tried that and it didnt work ... I have a 2011 Grand Cherokee Limited and my problem is that the fuel door stuck or ... There is a manual release in the cargo area. .... Itdoesn't sound like the internet is going to solve your issue.
https://answers.yahoo.com/question/index?qid...
Is there a way to turn off the daytime running
there are only 2 ways, JEEP dealer. (in canada that is illegal) so..>>>????or buy and aftermarket programmer that can do that.one brand i use is flashcali needed to turn all the bs off, on mine, horn honks, lights doing bswith keyfob and all, that is off on mine.do not guess, or listen to me, CALL them and ask them.
http://www.autoanything.com/performance-chips/61A7268A0A0.aspxtell them all things you want changed,and country , no country ever stated in this forum everand all that is gov buy laws of every country. so.... fess up.
Left turn signal and brake light not working on tow vehicle
bad wiring in tow vehicle, (connections) or at towing car side.
many cars, have towing options, factory and have relays and fuses just for the hitch connector.
so anything here can be bad, use a voltmeter AND FIND TRUE.
cause in 5min work.
Procedure for lubing caliper slide pins
undo the pins out of the caliper mount bracket. . leave the caliper in place on the disc rotor. Clean up any rust on the pins and lift the caliper a bit and clean out the holes with a bit of rolled up sandpaper.use neverseize on the pins and get some down into the holes of the caliper. position clipper and screw pins back in tight.
Not finding what you are looking for?