20 Most Recent 2011 Jeep Grand Cherokee - Page 9 Questions & Answers

2WD or 4WD...V6 or V8

Bad coil ,spark plug , wire .

jumber box left side of engie

even tho lights come on your battery may be to low to start just the other day i had same issue a person car would not start lights would come on i jump started the car and went got a new battery

Check your FLASHER in the Fuse Panel.

Hope helps with this (remember rated this).

Your description indicates the door hinges require adjustment. Usually the striker would be removed and the door hinges adjusted for easy closing and equal gaps. It is likely in your efforts to make the door flush with the front wing, mudguard or fender, the hinges are too far in. Most likely your replacement door is not identical to the original - not unusual for various reasons... Once the door hinges have been adjusted to provide a satisfactory position and closing the striker would be refitted and adjusted so it goes into the catch or latch dead centre - neither lifts nor pulls down the door as it closes. That is where the door needs to be and if it stands proud a little it is just bad luck - often the front fender can be repositioned and then the bonnet or hood readjusted. A competent panel beater would be able to tweak things for you to make them acceptable. It might have been better to fit a new latch to the original door.

This sounds like the Emission System needs to regen, If you have not modified the system you need to take the unit on a long highway speed drive in order for that to occur.

IT is Fuse #1 in the fuse panel under the dash on the drivers side.

Yes.

P0134....O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1)

P0135....O2 Sensor Heater Circuit (Bank 1 Sensor 1) heater in the O2 sensor has packed up first sensor before the cat

Does it have headlights ? Clean battery terminals first, charge battery if needed, jump start it across the terminals of the starter with key on. Could be battery terminals needs cleaning, battery, or starter ?

Anti-theft system problem ! need to take to the dealer !

Almost as important... what does NOT work? Anthony

The best solution you'll get from books at www.reliable-store.com These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc

The very 1st thing you do is get an OBD2 code reader and check for system fault codes.