20 Most Recent
2012 Hyundai Elantra - Page 5 Questions & Answers
2017 Elantra rear passenger door jammed. Will not open from inside or outside.
Hi is it that the safety belt
it is surely the safety belt that has jammed in door if so get someone on outside to hold it in the open position and the other one inside to push hard with his feet,it some times take a kick to open from inside not saying you should but there you are some times it the only way.
Take care all best to you. Clive
ERROR CODE 43 ON CD
I just got the same message today...and rarely use the cd player. Was wroking, went to change cd's, then it would not load and gave error 43...anyone?????
Bluetooth reset
Just for fun try unhooking your negative battery cable for a couple minutes to do a reset or reboot .
How to replace brake line on front brakes 2001 hyuandi elantra
Hose is held to suspension strut with c-clip, loosen and retighten union joint while still in clip for ease of undoing. then remove clip holding hose with pliers
Top up reservoir and to avoid fluid loss, Clamp existing rubber hose off above Wheel cylinders callipers. Spread brake pads slightly to clear disc rotor edge then undo callipers from hub - suspend from strut with cord or wire and unscrew old pipe. Immediately replace existing with new hose to callipers. With master cylinder reservoir sealed airtight undo union nut at top of existing rubber hose where clipped to strut. Replace existing lower hose fitting with new hose.Tighten union. replace c clip and bleed brakes at nipple on callipers until all air out of lines.
Job done road test for hard pedal repeat bleeding as necessary.
How to open the bonnet of Hyundai i10 car
Under your dash there is a small lever with a handle and marking. pull this for ejecting the bonnet. use your palm to push off the safety lack that hold the bonnet- safety for holding on during high speed/ wind if the bonnet lack opens- to lift up your boonet. You can look through the gap of the bonnet to see this safety latch.
now on top of the engine you will see the cap for the oil inlet.
Now beffore you do that , use the dip stick to look for the oil level. wipe it and check again. Only if the oil is down you need to replace. Also topping is not required unless the engine is old/bad. otherwise it is important to change the oil filter and oil along with your service. So check this out. Good day
Not finding what you are looking for?