20 Most Recent 2012 Hyundai Accent - Page 4 Questions & Answers

service bulletin on this B1448 Airbag light on Hyundai Accent Ricks Free Auto Repair Advice

I really think you should go to www.reliable-store.com they have got books on every vehicle and also how to service/repair it, parts info, wiring diagrams, electrical diagrams, fuse diagrams, error codes, etc everything

oil supply to valve train..

sounds like the backlights in the cluster may have burned out. are there other dash lights near heat control or radio that still work?

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????2

Your radio is in theft lockout, you need the security code that came with the owners paperwork new.

My personal suggestion would be to go for these repair catalogs. I know this website reliable-store that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet. also try manualslife com if you're at it I still look up at these manuals for reference all the best

Clean the MAF sensor and the IAC valve with MAF cleaner only...change your oil and filter, put correct air in tires and disconnect battery cable....wait 10 minutes, reconnect battery, turn off all accessories, lights, wipers, radio etc...put key in ignition and turn to the on position, BUT do not start...wait 1minute then turn off...turn on again and start car...do not rev, let car idle for 15 minutes, then go for a 20 minute drive. Before you take the car for another test, drive it for approximately 1 hour, both in the city and on the highway so the sensors can readjust....do not race or over rev the car...drive normally....cheers.

Sounds as if you may have brake problems or perhaps CV shaft joint failing.

If it is the panel located just below the radio, the bezel around the radio and heat/ac switch panel will pop out if you pry gently from the outer edge with a putty knife or something similar. The switch panel is attached to the bezel and has to be removed from the back side of the bezel. The bezel pops straight up from the dashboard.

P0650 Malfunction Indicator Lamp (MIL) Control Circuit Malfunction

Malfunction Indicator Lamp (MIL) is located on the instrument panel. When the ignition switch is turned ON without engine running, MIL will light up. This is a bulb check. When the engine is started, MIL should go off. If MIL remains on, the on board diagnostic system has detected an engine system malfunction.

Possible Causes:

Harness or connectors (MIL circuit is open or shorted.)

MIL bulb may be faulty