Top 20 2012 Honda CR-V Questions & Answers

Sounds like u are describing chassis springs on the struts or strut mounts. Have it ckd. Simple lube of springs may solve it or chassis svc.

When you first start the car up it sounds like a power steering whine. Have you checked the fluid level? Also get inspected timing belt ? For step by step troubleshooting click the link below: http://fexya.blogspot.com/2016/06/honda-crv-whining-noise.html ---- Thanks.

On all wheel drive all 4 wheels need to rotate at the same speed so as to not damage the drive gears. If a tire gets too low on pressure that wheel will rotate at a faster rate because it is now smaller than the other three. Damage can occur if not attended to.

Owner's manual should have the location.

Please be more specific on what "this" is... Is there a pic you forgot to add??? You can edit your question & others may chime in afterwards.

Make sure the shifter is fully in park position shift to n the to p then shake the shifter a few times

Please be more specific on what "this" is... Is there a pic you forgot to add??? You can edit your question & others may chime in afterwards.

Probably need a new thermostat..

Any reputable auto repair firm should be able to do this ok. Don't forget that you may be required to install a larger fuse or it may blow fuses as soon as you go to dim. Fuses are normally found under the hood or under the dash on drivers side.

I am not going to give you an answer for this but rather give you advise not to take it lightly making changes to the electrical system.

If it is humid out, a lot of water will drip onto the ground.

Perhaps you can use a broken screw remover that you can purchase from you local hardware store.

check for lost belt on P/S pump , or loose. check fluid level same.

On this website, you find fuse box diagram and description for Honda CR-V (2012 - 2014) http://www.autogenius.info/honda-cr-v-2012-2014-fuse-box-diagram

https://honda.portal.honda.ca/portal/esis/GPHTMLServlet//Honda/GP/Contents/SM/en/RIN/61T0AD00/SCT/SC/SYS/R000467_enu/web/html/R000467_enu.html Give this a try. I hope it works for you.

this may not be very helpful, but mine does it too...

Videos and images in the link. https://www.google.com/search?q=2004+Honda+CRV+oil+pressure+switch+location ..

where? what are you touching and doing, and viewing IDK>.

Check for fuel pressure at the injector rail. If no pressure, check pump circuit and relay. If pressure at rail, check injector fuse. It’s also possible the fuel filter is clogged.

It should run about $550 if a shop does it.