Top 20 2010 Honda CR-V Questions & Answers

blew radio fuse

No you must check sensor in tank

When the clutch pedal starts to feel stiff and hard to deptress it means that you will need to replace the clutch, the friction disk is worn out.

Float sensor in tank sticking or damaged

local honda service division will use the vin number to get you the code

It seems like you reset the PC the 2nd time, not the 1st time. The funs not over yet. find out where all tis oil has gone. Any leaks? Recently serviced? Bluish Tailpipe smoke? Find out about where the oil has gone! ck plugs for burnt oil. I'm sure your buddy could direct you further but don't let it go!

no it is electronic fuel injection

The quickest, simplest way is to call a Honda dealer and give them the VIN code from the car. Most will do this for free.

behind glove box, to the right. Can't miss it-has writing on it.

Fuse#23 in the under dash fuse box is for the tail lights, controls license plate lamps and side marker lamps as well. f if you meant brake lamps it's fuse 12 in the under hood fuse block.

the check engine light will stay in memory and you stould have the code read, autozone, NAPA can read the code for free, place the part that is bad, and u will be good to go

You will find your answer here go to page 2 of comments...CR-V No Tail Lights - HondaSUV Forums - Discussion forum and ...

www.hondasuv.com/members/showthread.php?t=59889

Light indicates a fault in the air bag system. Check and replace faulty item.

I am a Honda Master tech. There is no such problem for this vehicle. First things first, if the vehicle drives straight , but the steering wheel is off center, then that's what the problem is...the steering wheel is not centered. when an alignment is done to a vehicle the steering wheel is set be a technician (not by a machine). My advice to you is to take it back to the dealer and go for a road test with the service manager or shop foreman. show them what you mean. they will take care of you. good luck

Videos and images in the link. https://www.google.com/search?q=2004+Honda+CRV+oil+pressure+switch+location ..

where? what are you touching and doing, and viewing IDK>.

Check for fuel pressure at the injector rail. If no pressure, check pump circuit and relay. If pressure at rail, check injector fuse. It’s also possible the fuel filter is clogged.

It should run about $550 if a shop does it.

The ac fan only comes on when the ac is on , the engine fan comes on at engine operating temp . few things to check , the radiator core fins are free from rubbish leave or plastic bags , the thermostat is fully open , radiator tubes are blocked with gunk have it flow tested .

This may help: