20 Most Recent
2010 GMC Canyon Questions & Answers
Where's the radiator drain on a 2010 Canyon?
Hi at the bottom of the radaitor usually its around whete tje bottom hose is. Its looks sort of like a wing nut. Unscrewing it will open the pepcock and you can drain it
Also, if the engine is cool or cold you can remove the bottom hose to drain it as well.
Window squeak
i always use a oil can with engine oil in it and oil the side track runners ,works better than silicon spray and its cheaper ,could be the rubber scrapper on the outside is hard and needs replacing though ,they go hard with exposure to strong sunlight
My GMC Canyon won't start with neew battery, Next Day or week it will not start?
When battery voltage is lost, sometimes there are some modules that may need to be reprogrammed? It could effect your security system, where applicable. I don't know model year?
If it cranks good but won't start, make sure battery has a full charge. Have a helper crank it while you check for spark at the plugs. Also, check proper fuel pressure and fuel injector pulse. Find out what your missing, if anything?
2005 gmc canyon computer not ready and not reading codes
If the check engine light was on DTC'S - diagnostic trouble code's should be stored . If the light was on , disconnecting the battery won't do anything . Diagnostic's need to be done . Sounds like you have no clue , so best advice , take it to a qualified repair shop .
2008 canyon idles rough
Misfire , vacuum leak , Dirty throttle plate . Is the check engine light on ? Search rough idle on youtube .
08 canyon, keeps blowing 15 amp ign fuse
What is engine liter size? Does it blow with key on or do you have to start it? Most of the circuits for that fuse goes to ignition coils, coil on plug ignition. Could be a faulty coil or shorted wiring circuit, somewhere?
There was one other circuit, seems to go to control side of ac compressor relay, just for testing, you could unplug the relay, I doubt we'll get that lucky?
With key off, unplug ignition coil do an ohms test on coil primary terminals, I'm not talking about the wiring harness connector, the coil, itself. Look for the readings to be close to the same, if one is way different than the others, that coil could be faulty? Any applicable trouble codes?
What would cause the fault
It is most likely the abs sensor is dirty or bad,It won't affect the operation but it will prevent the abs feature from working.You can have it checked at any brake shop.Some will even do it for free.
How do I tune it up?
Oil Change & Filter
Transmission Fluid Change & Filter
Fuel filter
Air Filter
Plugs, wires/boots, cap & rotor if applicable
Clean the MAF sensor with MAF spray.
Clean any debris out of the air intake box.
Run some seafoam in the fuel to clean injectors.
Check tires & pressures.
Not finding what you are looking for?