20 Most Recent
2010 Ford Mustang - Page 6 Questions & Answers
What are the colors for fuel pump 84 mustang 3.8
I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from
www.reliable-store.com
All the best
2003 ford mustang gt. car was overheating so i
Hi Trevor,
I would be checking for a vacuum leak/air leak between the cylinder head and the Mass Airflow Sensor (MAF) sensor,
sounds like it is getting unmetered air past the MAF sensor.
Running a lean mixture will cause overheating issues and high
idle amongst other problems like low power, and rough running.
Also check resistance of the MAF sensor and Throttle Position Sensor (TPS), and give MAF a clean with Correct cleaner.
Double check and make sure all wiring connections are in properly around fuel system, MAF, TPS, IAC ect.
Cheers,
351C engine heater hose connector
I really don't know a lot about the vehicle you're just driving because your engine but you did say it's a 351 I think you should go to a machine shop because they may be able to fabricate a new intake for that might be your cheapest way to go it might only be 60 or $70 but don't you fix it right
Toyota ALTIS driver side window does not close completely
SOUNDS LIKE HEAVY LOAD ON UP DIRECTION. MY
GUESS IS A FUSEABLE LINK HEATS UP, STOPS ELECTRICITY, COOLS DOWN AND RECONNECTS.
IF UNDER WARRANTY, GO TO SELLER.
IF NOT A FREE REPAIR, WITH THE WINDOW DOWN, YOU COULD USE A SILICONE SPRAY ON THE THE VISIBLE WINDOW TRACKS. ALSO YOU COULD HAVE ANOTHER PERSON USE THEIR PALMS ON BOTH SIDES OF THE WINDOW TO ASSIST IN RAISING IT UP A FEW TIMES. IF THESE ACTIONS DON'T CURE THE RESISTANCE THEN A LOCAL MECHANIC OR GLASS INSTALLER COULD INSPECT THE CAUSE.
1995 Mustang and it wont turn on or turn off all they way
Some of the older cars with ignition switches in the steering column use rods to engage a switch in the lower part of the column, usually under the dash. The key switch may have gotten worn enough to get the rods out of alignment or maybe even bent. This is a 22 year old car and things can wear. The key switch may have to be replaced.
Hi, my 1994 Mustang won't start. No spark. I
You must check the module for moisture or bent pins or not tight enough what size motor is it and who did the rebuild also please try to be more specific right now I don't know what you have in it as a motor and is it a swap from an 6-8 or is it 5.0-4.6 ?
Fuel trim bank one condition
Yes, too lean is the problem. Just means "not enough gas" is flowing. Could be as littlie as a plugged up gas filter or worst scenario, a bad fuel pump. Either way, it isn't getting enough fuel into the engine. When it WAS running, and you pushed the throttle all the way open, it was then getting way too much air for what little fuel was going in. That's why it did what you said.
I have 97 ford mustang
The twenty amp maxi fuse in the under the hood fuse panel goes to, you guessed it, the fuel pump. It sounds to me like you have a short to ground in the wiring that keeps popping this fuse. Find and fix the short, or you will keep blowing fuses.
Not finding what you are looking for?