20 Most Recent 2011 Dodge Journey - Page 8 Questions & Answers

Inspect wire for corrosion bfor addtesin injector. It cud b leakn..but hard to tell from rapid evap. Paint it n watch if gas dissolves

Is the check engine light flashing? I will bet It misses at all RPM's, not just at 2000.

Randall, remove all screw,clips,fasteners securing bumper and then any wiring harness plugs etc. attached to bumper. This is some times a 2 person job, to prevent damage to the bumper, especially when installing. A V-pry tool may be required to remove plastic fasteners easily. Check the attached links,instruction and guides, Good luck "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info." 2012 Dodge Journey Crew V6 3 6 Bumper Components Diagram Removing Plastic Auto Body Fasteners How to Paint and Install Plastic Bumper Cover Spray Paint

It has to do with the oil pressure in your motor.could be a bad pump at worst. Any reliable shop or dealer should be able to help.

The fuel line will connect the fuel tank and the engine. Fuel pumps are commonly located inside the gas tank. They can be a pain. Check fuel pressure before you start replacing the fuel pump.

It's 35 miles. You'll find Mapquest to be helpful. Here's a link- MapQuest Maps Driving Directions Map

Are you talking about tail lamps? What is model year? As far as bulb replacement your owners manual should have that info.

you need a DRB III

the block maybe the same but not the sensors or intake and manifold, they must be swapped

Type your question into search area of www. Utube.com and look for a video on trany speed sensors of Dodge, Chrysler , Mopar

Seen this problem Yesterday, we think it is a door blend actuator, but if it is only 5 months old take it back to the dealer and have them complete the warrenty.