20 Most Recent 2010 Chrysler PT Cruiser Questions & Answers

Question edited for clarity. Question moved to model category. Where did you get this 'fault 14' from? Diagnostic Trouble Codes are normally 'P0123' in format and P0014 is something completely different. Communication codes start with a 'B'. Generic advice https://www.google.com/search?q=2010+Chrysler+PT+Cruiser+ABS+fault+14 How to review DTCs.

check that you have used the correct bulb for replacement as some bulbs have 2 connections and some have 1 and are not interchangeable.

Hello. It seems your Chrysler PT Cruiser's starter, finally, wore out. Yes, the 'hammer trick' works is a temporary fix but doesn't last long. Attain another starter and that starter issue will be gone; for now. Good luck and keep me informed; if you want to.

Sun roof ¿ wiper motor compartment full of leaves rust issues door seals?

There is a emergency release on the left rear seat latch that allows you when pulled to push the seat open to gain access that way, not through the trunk hatch

you are dealing with 2 issues code p 0325 refers to knock sensor (KS) 1 bank 1--circuit malfunction ====causes ---wiring ---poor connection ---KS code p 0340 refers to camshaft position sensor(CMP) sensor A bank 1--circuit malfunction===causes wiring--- CMP sensor ---ECM code p 0344 refers to CMP sensor A bank 1 --circuit intermittent===causes --wiring --poor connection---CMP sensor --ECM check wiring and connections before replacing the CMP as the wiring may be the cause of all the codes

Once a particular system is displayed, short and long presses of the STEP button will move the EVIC through the system menu. Pressing and holding theSTEP button once will clear the resettable function currently being displayed. Reset will only occur if a resettable function is currently being displayed. To reset all resettable functions, press and release the STEP button a second time within 3 seconds of resetting the currently displayed function (Reset ALL will be displayed during this 3 second window). I hope this helps you, let me know if you have any trouble changing it back to english. Thank you, Locksmith East Aurora Ny 24 Hour Locksmith 716 249 2944 in East Aurora Ny

run the fault codes as it may be in limp mode.

Does the release not work, or are the gas pistons just worn out? Your question doesn't provide enough information to answer...

Brake on and move shifter to N - neutral. Start in N

see the diagram attached. and fix it. God bless you

If none of the brake lights are working than checking the fuse would be a good start. The owners manual will have all the fuse information you will need. I'm pretty sure the brake fuse is in the underwood fuse block by the brake fluid reservoir. If the I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Your vechicle should be warm and in neutral, to check the fluid level.