2011 Buick LaCrosse - Answered Questions & Fixed issues

This often happens when the vehicle looses power. It is part of the anti theft system. There should be a code in the owners manual to unlock it when it prompts for the code. If there is not one in the manual or you don't have the manual, you will need to visit a dealer to get an override code. They should be able to give you a code for it in the future.

https://www.gmpartswarehouse.com/oem-parts/gm-temp-sensor-9152245?origin=pla&gclid=EAIaIQobChMIpbTEwsXI4gIVkLrACh1jIAfSEAQYASABEgKx3PD_BwE

You don't , unless you have a $6,000 factory scan tool . Your best bet , take it to a buick dealer . Electronic's an a control module involved .

Must be check door handle.

That noise is most likely the valve lifters, some noise is normal on these GM engines, if it is really noisy that is a problem. Do you use the correct grade of oil and change at least every 6,000 miles.

Since you have no power to the ignition switch( you can't get the key out). Look to the main fuses first. You can see them threw the top. If the solder joint isn't shiny, pull them first. Since it did start and run, it isn't the ignition switch. Wiring most likely in place. Fuse panel could be bad. I've replaced a lot of them. But not with out diagnostics.

On newer vehicle's if you don't use another power supply when changing a battery modules can go night - night an not wake up ! Battery Disconnect or Replacement Problems Then your stuck having your vehicle towed to the dealer !

There could be many problems in this situation. Here is a list of some things to check: 1.) Check the wire connection in the door jamb where the wires transfer from the vehicle to the door. Sometimes these connections get a little off and things start acting goofy because the door being open and closed all the time(nothings perfectly designed). 2.) Check the relays in the fuse box, I can't remember if on this model vehicle if they used separate relays for each door or just one for all of them, but the relay could be bad. 3.) Check the locking mechanism inside the door by taking off the door panel and using a multi-meter and a 9 volt battery. I've checked the locking mechanism inside doors with a 9 volt battery before to make sure the mechanism was able to do it's job without being hooked up to the vehicle's power source

Try replacing the bulb.

IF YOU PUSH THE BUTTON AT THE BASE WHERE THE SHAFT GOES INTO NTHE SEAT AND PULL UP IT SHOULD COME OUT

Don't know about your car specifically, but most cars with electric fuel pumps are equipped with a oil pressure switch which cuts power to the fuel pump when oil pressure drops. The idea is that in a wreck when engine dies, pump should not run in case lines are cut which could dump fuel on ground and create fire hazard. Switch usually located with normal oil pressure sender.

Pull the back seat back rest off crawl into trunck. Pull trunck release. If that doesn't work Lock Smith.

Hi Keven, I'm Al the owner of Big As Auto Repair Keven, that flip down cover can be a bear to flip up some times especially if its been on there a long time. Take a screw driver and lay something across the battery to use as a ramp and take the screw driver and using the ramp pry upward on the very end of the cap and it should pop up. NOTE: Be careful though because some of those covers actually unlock from the other end. Hope this helps and if you need further assistance go to my website. Have an awesome day Keven! Auto Repair

Try using a Drain cleaner first, then go for the big guns, such as a drain snake.

need to put high octane gaz only

You need to put a radio code (most are a four (4) number code) If it is not in your owners manual, in the radio section, then you will need to go to the Dealer to get it.

Visit a local Autozone and purchase a R134-A charging kit. Comes w/1 can of 134-A and the connection hose needed for your vehicle and can. Follow the directions very carefully !!! Wear protection goggles, mechanics gloves, and be careful. Note: Engine must be running and AC must be on High Cool for the system to accept a freon charge.

there is an exact amount of gas to put in the system and if there is insufficient gas as you think then it would be advisable to have the system checked out for leaks otherwise you will not achieve anything.. Take it to an accredited auto air conditioner shop and save money.

reset remote if dealer remote ask them to reset remote

If the shiftier does not go into park all the way , this will keep the key from coming out ...