20 Most Recent
2005 Hyundai XG350 Questions & Answers
My uncle says that 3
If its a V6 front wheel drive, 3 on the left head (rear) and 3 on the right head (front) if it is a straight 6, all 6 are in line on the single head. 4cylinder, all 4 in line on the single head......Mike
My 2004 Xg350 is stuck in limp home mode.
code p1155 refers to electronic throttle system (ETS)- malfunction===causes --wiring--ETS limp home valve
code p1193 refers to ETS -limp home valve --on===causes --Low RPM
code p0302 refers to cylinder 2 misfire detected===causes--engine mechanical fault--wiring---ignition/ fuel system---injector---ECT/MAF sensor---ECM.
Pulling a battery lead to reset is a waste of time as it corrupts the CPU program. Use a code reader to reset . It is quicker and doesn't run the risk of program corruption
I have a 2004 xg350
Cheaper to start with fuses but It could also be the relay box if you look at the back of the cover that is covering the fuse box there should be a diagram showing were each fuse.
Not 100% shore but worth checking as there could also a fuse box with fuses and relays in the engine bay
Let me know if this helps
Regards Craig
My xg350 hyundai, 2002 is
The fan kicks in when the car reaches a certain temp. Try running it for a few minutes and keep your eye on it. If it doesn't run at all, could be a bad thermostat or simply a fuse.
Leaking coolant is an issue. Look at your radiator hoses. They should not be bulging, cracked, split, or dry rotted. If they are, they need replacing.
When a car reaches temp the thermostat tell the fan to start, and coolant starts circulation through the water jackets (little channels in the engine block). If this isn't happening, your car will over heat and engine damage will occur.
Replace timing belt on 2005 hyundai xg350 v6
When I did a timing chain on my Datsun I set up TDC on number 1 cylinder and then used a dob of paint on each pulley and a fixed point on the engine so that I could make sure everything lined up the same when I changed the chain.
Transmission
Your problem is a bad CV axle and outer carrier bearing failure. The grinding is coming from brake rotor on that side due to the bearing failure. the brake rotor and bearing is causing the lock down. Do not attempt to drive or further damage will occur. Transmission is probably OK. Replace both sides (CV axels and Carrier bearings, 150,000 is time) Check brake components for damage and replace pads while you are there.
Not finding what you are looking for?