2009 Ford F-250 Super Duty - Answered Questions & Fixed issues
Ford clock
Chechen your fuse links off the battery and the body control module
Gas tank venting
There is usually a solenoid in the vent system which allows for a Vacuum pull in the system. This is suppose to disengaged when the key is off. Sounds like the solenoid is stuck and the tank can not vent.
Front lights dont turn on. on a 2000 ford f250 super duty disel
I would look for a problem with the headlamp switch. Also it could be in the multipurpose switch which is part of the turn signal switch I have seen both problems. You will need a test light that will light when you probe 12 volt wire. Follow the 12 volts from the fuse box, some trucks fuse the headlamps, so make sure they are all aright. Follow it to the head lamp switch to make sure it has current and if it does, probe the wires that are connected to the multipurpose switch. Make sure that the headlamps have a good ground and that they are both not bad.
2002 F250 V10 with trouble code P0720
The OSS or Output Shaft Speed Sensor is located in the top of the tail shaft housing of the transmission just before the driveshaft, it is an 8mm bolt that holds it in, very tight place to be but can be change fairly easy.
1999. Why is A/C air flow poor?
air flow from and air conditioner is dependent on the condition of the heater blower fan
so check that the blower fan is operating at all fan speed settings
next if you live or use the vehicle in dusty conditions , the dust will build up on the evaporator fins ( condensate water and dust = mud and gunk) and blocked evaporator fins ( this will result in reduced ac operation as well
the dust is not always from out side air through a cabin filter ( may be blocked) but from dirt that is introduced into the cab from dirt on the foot wear
Were abouts is the front and rear axle rating tag
THERE IS A TAG EITHER ON THE DRIVERS DOOR OR THE DOOR PILLAR THAT WILL SAY WHAT THE RATING IS IF THERE NOT THERE CALL YOUR FORD DEALER PARTS DEPARTMENT AND GIVE THEM THE VIN # AND THEY CAN TELL YOU WHAT IT IS
The code came up p-0743 how do i fix this
You replaced the O2 sensor and the other codes popped up ?I would clear the codes and see how many return. Often times the problem is not the sensor but rather something in the engine performance.
Not finding what you are looking for?