2013 GMC Acadia - Answered Questions & Fixed issues

I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

2013 GMC Acadia | Answered on Feb 02, 2019 | 33 views

the dealership has not tried everything if they have not done a compression test
water pumps seldom are responsible for overheating as their major failure is bearings and pump seal
if it has plastic radiator tanks, the plastic cracks and there is no pressure build up so the coolant boils off at a lower temp
there are a lot more tests that can be done other than what the dealer did

2013 GMC Acadia | Answered on Mar 25, 2017 | 121 views

Contact the dealer for the location of the blower motor and then roll up your sleeves and get to work!

Before you take out the motor you might want to verify that it is receiving power. If not receiving power the motor could be good and the problem could be with the wiring - no need to replace a motor that is still good!!!!!!

2013 GMC Acadia | Answered on Nov 01, 2015 | 284 views

What's the trouble Rich , A 2013 shouldn't need refrigerant added already ! Unless you work on A/C systems all the time I suggest you take it to someone who does . These newer system take very little refrigerant , an is very easy to over fill , which means it won't get cold , just like with too little refrigerant ! It should be evacuated an recharged , the recharge is weighted to exactly the right amount ! They shouldn't be allowed to sell refrigerant too the public , me as a tech , I have to be certified ! If I let refrigerant escape into the atmosphere I can get fined , it should be the same for joe Q public !

2013 GMC Acadia | Answered on Jun 07, 2015 | 62 views

most likely leak in one or more of the vacuum lines and or out door air damper not closing

If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352

2013 GMC Acadia | Answered on Mar 02, 2015 | 403 views

stuck where, and when? (stuck in PARK>?) ??????????
all automatic cars have a feature called park lockout.
this car is under warranty, and most cars there is a bypass method stated in the operators guide, did you look there , in that book in glove box?
key on, step on brake, and see if you can get it to shift.

one some newer cars they took away the bypass feature. those cars should be avoided, (why invite getting stranded for so silly a reason ,huh)

page 9-19 shows no bypass... says call dealer.

the same book, shows, car can never be flat towed.
(no park bypass)

2013 GMC Acadia | Answered on Jul 11, 2014 | 274 views

the car has many systems
name one.

what lever, where.

2013 GMC Acadia | Answered on Jul 02, 2014 | 22 views

Everything you mention is in the same door. Look for a connector between the body and the actuators in the door. This may be accessible or just inside the door itself, past a rubber grommet. Pull the connector apart and inspect it. Spray with silicon or WD40 and reassemble.

GMC Acadia Cars... | Answered on Apr 21, 2019 | 32 views

Is it the Bendix? Is your alternator working? Is your fuel pump working correctly. It could be a few things, just troal and error. Good luck.

GMC Acadia Cars... | Answered on Mar 02, 2019 | 34 views


GMC Acadia Cars... | Answered on Jan 01, 2019 | 42 views

Check out this video. You could have a blower motor problem. https://youtu.be/6IcD0jYLV3Y

GMC Acadia Cars... | Answered on Dec 14, 2018 | 2,398 views

Engine off,ignition on, gas pedal to the floor 3 times.

GMC Acadia Cars... | Answered on Nov 25, 2018 | 70 views

usually the underneath connector is just loose .try to remove the connector and clean .if the same problem occurs check the for the ground and blown up fuse

GMC Acadia Cars... | Answered on Aug 11, 2018 | 469 views

On most vehicles there are 3 blinker bulbs on each side. One at the front corner, one at the rear corner and a third side repeater usually mounted in the front wing, (fender).
Some more modern car companies have started fitting the side repeater into the door mounted 'wing' mirror body.
The blink rate will usually be around 60 to 120 flashes per minute. If the rate on yours is usually slower, a higher speed flash suggests there is a blown or missing bulb.

GMC Acadia Cars... | Answered on May 17, 2018 | 34 views

DTC P0877: Transmission Fluid Pressure (TFP) Switch 4 Circuit Low Voltage

The transmission fluid pressure (TFP) switch 4 is part of the control solenoid (w/body and TCM) valve assembly and is not serviced separately. The TCM supplies 12 volts to the TFP switch 4 on the TFP switch 4 signal circuit; the TFP switch 4 has an internal case ground. TFP switch 4 is normally closed, Low. When oil pressure is present at the TFP switch 4, the switch is open, high. The normally low clutch pressure control (PC) solenoid 4-5 controls the transmission fluid to the 1-2-3-4 clutch. The TCM monitors the normally closed TFP switch 4 signal circuit to determine the 1-2-3-4 clutch status.
The TCM detects that the TFP switch 4 signal voltage remains low, 0 volts when the 1-2-3-4 clutch is commanded ON for 5.5 seconds or greater.

Action Taken When the DTC Sets
• DTCs P0877 and P0878 are Type C DTCs.
• The TCM freezes transmission adaptive functions.

Circuit/System Testing
Ensure the TFT is near the temperature displayed in the Failure Records.
Start the engine and place the transmission range selector in D6.
Observe the TFP switch 4 parameter while commanding 4th gear and then commanding 5th gear with the scan tool. The TFP Switch 4 should transition from High in 4th gear to Low in 5th gear.
? If the TFP switch 4 parameter state does not change, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
? If no concerns are found, replace the control solenoid (w/body and TCM) valve assembly.
Component Testing
Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control solenoid (w/body and TCM) valve assembly replacement - refer to Control Module References for replacement, setup, and programming.
Perform the Service Fast Learn Adapts

GMC Acadia Cars... | Answered on May 13, 2018 | 512 views

My personal suggestion would be to go for these repair catalogs. I know this website www.reliable-store that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.

GMC Acadia Cars... | Answered on Feb 28, 2018 | 405 views

There should be a lever at the base which allows the seat to fold forward then a secondary latch unlocks the pivot to allow removal.

If you need further help, reach me via phone at https://www.6ya.com/expert/james_8f14c50d9c6cdea8

GMC Acadia Cars... | Answered on Feb 23, 2018 | 37 views

Fuel injector cleaner

GMC Acadia Cars... | Answered on Feb 05, 2018 | 40 views

Not finding what you are looking for?
2013 GMC Acadia Logo

13 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top GMC Experts


Level 3 Expert

84625 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides