20 Most Recent 2013 Ford Edge Questions & Answers

Not easy to find the first time!

Where is a block heater? - 3.5L

Ford Edge Forum https://www.fordedgeforum.com > ... > 3.5L Nov 14, 2021 - All Edges are made in Canada, block heaters are never standard on US vehicles, I don't have the 2014 Canada order guide but I do see the 2021 ... 2017 ford edge block heater 6 posts Jan 12, 2020 Another Block Heater Question - Ford Edge Forum 8 posts Dec 29, 2013 2007 Edge Block Heater cord - - Mods & Tech 10 posts Dec 13, 2009 Block Heater - 2008 Edge & MKX 3 posts Oct 17, 2012 More results from www.fordedgeforum.com ..

Hi Paula I see you have a remote control for the alarm on your key or a separate key fob and these are very sensitive to touch and just from having it in your pocket/book or from tossing your keys on the table can depress the trunk button and bingo it opens and you don't know it try to observe the liftgate being aware of holding the key and then putting on a table face up away from the buttons and see what happens a couple of times if it doesn't do it anymore that was it if it does do it check all your fuses if ok next check if your liftgate sensor is shorted out especially when it's rained out or the carwash you could be getting in water from a leak also is this a liftgate that you can close with your foot if so check your license plate bulbs and tail light bulbs some of these sensors take power from those circuits

It will be wherever the person who installed it put it. If you can not find a cord anywhere under your hood you probably do not have one.

IFf it doesn't come out when you push eject button normally, knock all power off and hold your finger on eject button as you turn power back keep holding the two together for about 10secs

Your antifreeze maybe low or you have a bad radiator / reservoir cap !

Watch the video at the link, the info is in the video of the dash removal process since he speedo must come out to remove dash assembly. How to re install or remove dashboard on 2014 Ford Ranger

Hello, Sounds like the flap that controls the cold air and hot air duct is not working. One duct pulls air through the heater core where the other duct draw air from the outer vent. If that flap is not working, allowing you to pull from the heater core duct, then either the switch/lever that controls the flap is faulty (more likely) or the flap is stuck (less likely). Hope this helps.

When you say breaks do you mean front wheels when driving? Or do you mean that when you apply the breaks at fast speeds the car vibrates. If it is the first, then your alignment is most likely off. If it is the second then you could have a caliper sticking or need your rotors resurfaced because they could have warped.

Have engine mounts and axle cv joints checked for wear.

Best to have it reset by a dealer or service agent.

If you 100% sure the fuses are good (check again) then you have connection point problem, and because it is all aux power points it has to be a connection behind/under the fuse box OR a break in a connection or broken wires between fuse box and firewall entrance. You will have to use wire tracing test tool (probe type with light) and test the entire length of the wires you can seen and access to find a break/disconnect.

2022, 6,000 miles and brand new. Sort of bull, but not. The code tells the problem, but once the engine malfunction light go out, it is lost to the driver. However, all codes should be listed historically hiding in the background of the ECM that can be read with a pro grade scan tool computer, the sort that cost $3,500 to $5,000. These scan tools can also record what happens in real time. The dealership needs to keep it, drive it and record when it happens. If it only happens for a couple of seconds, you are not going to be able to catch it but they should be able to access those stored codes. If you are anywhere near Tennessee, reach out to Scotty Kilmer on YouTube. He loves calling out the likes of Ford for shoddy workmanship. He also has a number of those pro grade scan tools.