20 Most Recent 2009 Toyota Tacoma - Page 8 Questions & Answers

yes

After it has been running, it could be catalytic converters clogged. Pull a O2 sensor near the engine and see it it runs better. It will be loader. But if it does, replace the cats. Could also be a clogged fuel filter. They have the pressure to run the engine, but under a load, the volume isn't there.

take it to your dealer

There no 'kill switch' but the computer will stop the fuel pump in case the airbags are deployed.

Checfluid level. May need to disconnect batt to clear any solenoid issues. Cud be mechanical problm w linkage. Library has shopmanuals

see link below for information regarding the query

Download Link: http://www.repair-guidebook.com/1998-2000-toyota-tacoma-factory-service-repair-manual-pdf-download1998-1999-2000

blend door hanging open from bad seal or trash.

Its often called an oxygen sensor and is located in the exhaust manifold or in the front pipe to the manifold. There is usually 2 sensors...One before the converter and one after the converter

remove the belt and start the engine ..IF THE NOISE disappear it might be idler bearings that driven by belt but if the noise still there check the pcv valve..

That is the oxygen sensor. IT is on the exhaust manifold.

That is a fancy way of saying OXYGEN sensor. The oxygen sensors are heated by a wire to get to a very high temp. When the heater wire breaks you get this error..

TACOMA OIL CHANGE by me: http://youtu.be/xbv7mrDvmD8

You can buy an insert kit and rethread the stripped head. Just be careful and get some pro help and advice when doing it . It's really not that difficult.

did the fan belt fall off. for pump.? does it slip that belt? is the fluid at the correct level, (steering) , if stiff in air, (jacks) its serious issues. with steering.