20 Most Recent 2008 Subaru Impreza Questions & Answers

The first step is to verify that the tail light bulbs are not burned out. I Next step is check a) if you get+12v on the bulb, and b) check for poor grounds to rear light cluster. There is a fuse for parking lights. If all this check out then trace the wiring harness under the carpet from the driver seat to the rear for rust/water damage.

Check this link out to give you an idea.

How To Install Replace Windshield Washer Reservoir Bottle Subaru Outback...: http://youtu.be/3aUNVOJWLhA

Fuse kept blown means your wires are shorted to ground somewhere in the remote control module or your map light. Since when you press the remote the map light also turns on, I'd try something simple first. Remove the map light BULB from the circuit to check if that circuit is the issue to isolate the problem.

Being in the trade for 35 years, I wouldn't go lower then 1.5mm, the lining might come loose if go lower.

Check your tail light fuse.

Maybe. You would need to get the engine computer scanned for trouble codes to proceed. As long as the check engine light is on the cruise light may stay too.

The belt and the tension on the belt may be the problem. The belt will be available from the dealer spares department or any other auto spares shops . Some pumps start to become noisy if the turn is held on full lock as it makes the relief valve in the pump work . To check this turn on hard lock and if the noise appears back of the turn a little and the noise should abate

Because it takes more power to operate the air conditioner when it cycles.The throttle position sensor kicks up the idle a few hudred r.p.m.s so it doesnt bog your motor down.

The "Sport" light has to do with what position you have your suspension control in. If you need an Owner's Manual you can download a free one after opening an account at MySubaru. This is the official web site for Subaru owners.

Sounds to me like an inspection of the fuel lines and fuel tank need to be done. It could need replacement fuel lines depending on how many miles you have on the vehicle

This is a bit of an awkward one on that car, but you have to remove the wiper arms, then remove the retaining nuts on the spindles, the wiper motor and get to the inner wiper control arms. There's a chance that one of the nylon cups which connect the control/drive arms has popped off and simply needs to be reconnected.

You'll have to figureout if it is a fuel or ignition problem.What are the trouble codes ?