20 Most Recent 2009 Saturn Outlook Questions & Answers

How many fuses operate the liftgate of a 07 Saturn Outlook

Have you had it check for codes...Autozone and Oreilly can check the codes for free.

If replacing the coil-pack helped, it might well be something else in the HT-ignition system which is a bit off. Have a look at the condition of the plugs, plug leads & distributor & the wiring to the electronic ignition pack. Best of luck.

Potentially could be an oil pump, as if you have a situation where oil pump pressure drops due to a failure in the pump, the motor could make some noise from lack of oil and the MIL light/Oil Light would illuminate due to lack of oil pressure.

contact the manufacturer , technical division direct by phone and make the inquiry

The problem you have is water is getting into the control switch on the drivers door when it rains. What you need to do is take the control unit apart and clean the contacts .Its not hard the cover will pop off with a butter knife you will see the pad under the buttons under that are the contacts . You can use rubbing alcohal to clean the contacts and it will snap back together with ease

Get a spark plug socket for 3/8" ratchet and a 3/8" ratchet extension probably at least 3" to go with your 3/8" ratchet. The socket must match the size of your new spark plugs. Find them and replace them by removing the boot (rubber wire) on top of each plug. However many cylinders you have = how many spark plugs. Find them all. Put a little oil on the threads of the new ones so they don't sieze.

Unless you have the right tools, in this case a strut vise, pneumatic strut compressor, and strut clamps, you need to take it to a reputable dealer or mechanic who has the tools. Changing the strut is dangerous even if you have the right tools, so save yourself some headache and a trip to the hospital and pay to have it done. That is my suggestion.

go into the setting menu on the dash and make sure it has not been altered. there may be an internal fault with the auto express/window control module.

The compresor is supposed to cycle on and off. It is either overcharged or not enough.