20 Most Recent
2009 Lexus IS 250 - Page 4 Questions & Answers
Suddenly my abs and powersteering
Hello and welcome to FixYa!
What fuse was replaced? You may just have a system failure. As a first course of action, I strongly suggest that you remove the positive battery connector and let it sit for at least 5mins. before reconnecting it. This will reset the system and can get it back to it's normal operation.
Hope this helps and thank you for using FixYa! Have a good one!
Code po390 wires came off
If your connector has only two wires... A. It may not matter. B. Look at the connector for a different color clip inserted into it. Removing the clip should allow the piece that holds the wires to release, and maybe there is enough wire there for you to see which goes where.
Just remember how it goes together.
A dealer can tell you or simply see if they have a similar model on the lot, and ask to look under the hood.
Engine light is on tcs
the tcs can mean 2 things, 1 is the temperature colant switch, which is mostly located on top of the intake manifold, and sometimes close to the thermostat housing, this is based upon what type of vehicle it is, and the engine size. also unless your computer might be saying throttle control sensor, or switch. this switch should be located close to the throttle body area, after replacing or checking out the part, you can remove the light , either with a ob 2 scan tool, or disconnect the positive battery cable for about 1 minute, then reconnect it back up, light should now be out.
Manual says two low-beam versions,
Bulbs are usually not interchangeable as the wrong type won't fit. Find the bulb type by removing one of the old ones. replace both of the low beams at the same time. If you buy two of the same variety and they are the right bulb number (H7 is a style of low beam) they are okay to use, Change in pairs so beam color and bulb life are the same.
Not finding what you are looking for?