20 Most Recent 2008 Lexus IS 250 - Page 3 Questions & Answers

Frankly, I would check locally to see if there is a Japanese translator that would do this for you for a small nominal fee. You can check public libraries and courthouses for possible translators. Craigslist is also another good resource. Check local colleges for persons taking Japanese language!

Someone who can translate is willing to do this for a small ($20?) Fee. Good luck!

I got this free Pdf manual from an online store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the all the times I fixed the chipper in these 4 years

have blown speaker some one turn it up to high and blew it replace it and what the volumne

That hard of an impact caused damage to the sensors for the antislip and brake system. Make an insurance claim because this needs to go to a dealer and could be expensive to fix.

Pedal Relearn Procedure Accerlerator Pedal Released Postion Learning is and operation to learn the full released postions of the accerlerator pedal by monitoring the accelerator pedal sensor output signal. It must be performed each time harness connector of accelearator pedal postion sensor or ECM is disconnected. 1. Make Sure the acceleartor Pedal is fully released 2. Turn Ignition switchON and wait at least 2 Seconds. 3. Turn ignition switchOFF and wait at least 10 Seconds 4. Turn Ignition switchON and wait at least 2 seconds. 5. Turn Ignition switchoff and wait at least 10 seconds Throttle Valve Relearn Throttle ValveClosed Postion Learning is to learn the fully closed postion of the throttle valveby monitoring the throttle position sensor output signal. It must be performed each time harness of electric throttle control actuator or ECM is disconnect. 1.Make sure accelerator pedal is fully released. 2. Turn ignition ON 3. Turn igntion switch OFF and wait at least 10 seconds. Make sure that the throttle valvemoves during the 10 seconds by confrming the operating sound. (You can hear the TB sound when you have key on and shifter in first gear and step on the gas. So you know what you listening for.) Idle Air Volume Relearn Procedure The Following Condtions Must be met in order for procedure to Work. Battery Voltage :More than 12.9 volts at idle Engine Coolant Temp 158-203 degrees Farenhiet Electric Load Switch OFF i.e Air Condition, headlamps , rear defogger Steering Wheel: Neutral Postion (Straight Ahead) PNP Switch: OFF (Park Neutral Switch i.e. Clutch Switch...pretty sure) 1. Perform ACCERLEARATOR PEDAL RELEASED POSTIONS LEARNING 2. Perform THROTTLE VALVECLOSED POSITION LEARNING 3. Start engine and warm it up to operation temperature 4. Turn igniton switch OFF and wait at least 10 seconds 5. Confirm Gas Pedalif fully realeased, then turn igniton switch ON and wait 3 seconds 6. Fully step on and release gas pedal5 time within 5 seconds 8. Wait 7 seconds and fully step on gas and stay on until MIL stops blinking and is steady. 9. Fully release the Gas pedalwithin 3 seconds after the MIL has turned ON steady. 10. Start engine imediatly and let idle. Wait 20 seconds.

Thread Lexus IS 250 350 ISF TPMS Reset Procedure Try this link to know more. http://electronicshelponline.blogspot.com/

5 speed or auto transmissoin clutchs are bad or going out

If its a front wheel drive more then likely its the half shaft That's a drive shaft on the rt front