20 Most Recent 2009 GMC Canyon - Page 5 Questions & Answers

Really need more info but if it blows fuses you have a hot wire touching metal somewhere......
or something plugged in where it shouldnt be.....Or wrong size fuse..You have a brake light switch attached to the brake pedal which is common to fail.....also brake light bulbs and fuse ...check where bulbs are installed at recepticles....check for naked wires touching metal.....also use a good rated fuse...
should be a 15 some are 10 some 20...i would try a 15 if you dont know..................Sometimes your foot can accidently kick wires loose under dash at brake light switch........some cars also have
a cruise control switch above brake light switch.....DONT confuse one with other....NEED MORE INFO ABOUT VEHICLE TYPE TO GIVE CORRECT ANSWER................METALPOET

Obviously there is an electrical connection issue that is not easily solved with hands on the vehicle. You mention why the fault codes. What fault codes are stored in the PCM?

Give me some more information about this problem. May be i can help.

the shift silnoides are at the rear of the valve body you can see them in the pictures, it is a row of 3 silnoids remove them and you will find the filter screns onder them.....good luck

let me know if there is any thing else you need.

Sounds like the water got in the alternator and shorted it out. Have the alternator output checked.

turn on your vehicle and then disconnect the negative cable on the battery, if your car dies, then either the alternator you just got is faulty(which does happen), or it is not properly connected. If it stays running, then your alternator is working properly and you may have to check your battery cables for corrosion, and if any, replace. Also, clean your battery posts and cable clamps.

Even though the transmission is shifting like it normally does, the torque converter may not be locking like it should be. That would give the feeling of the engine being normal but the acceleration not being 'solid'. If the engine seems to be running normally, the problem is likely the torque converter.

Hi,

Thank you for contacting fixya.com.

If you have the leather seats, there are clips that prevent them from being extracted easily. On front seats some are released by squeezing the seat back cushion around the base of the head rest posts or when you flip the seat forward the clip is released. Otherwise, remove the carpeted hard back, usually held in with pop clips, to access the head rest post clips. Slide the clips off and remove the head rests.

Also check if there is a little hole in each plastic base of the metal bars. You need a very small screwdriver, allen key or paperclip to insert into the holes while pulling up on the headrest and it will come off.

Please get back to us if you have further query else please accept the suggestion.

Test the Alternator & If the battery is from
06 & overcharged,etc replace it.

I don't know what you want here

I guess you already knew what I suggested

Sounds like a bad blower motor resistor.

I can give you more info but I would need the year, make, model, and engine size of your vehicle. I would also need to know whether you have manual or automatic HVAC.

The more info you post the easier it is for us to help. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

you have a short in your swithch needs to be replaced pobably a dealer item


if it helps please give me thumbs up

Yes, it's normal. Only if you need more than 1 liter per 1k km then you have a problem.

the O2 sensors are located in the exhaust system, depending on what year, model, and engine size. their could be as many as 4 O2 sensors there will al wise be at least 1 and sometimes 2sensore in front of the catalytic converter and depending on the year the will also be 1 and somtimes2 behind the catalytic converter.

The load rating on the tire is per tire.33 psi will be fine,but for some added fuel savings I would air them up to the 44 psi in the rear.Don't for get to let them down when you remove your load or you will get center tire ware.