20 Most Recent 2009 Ford Fusion - Page 8 Questions & Answers

I'm going to assume for simplicity's sake that you're talking about the evap canister purge solenoid, I've heard it called the vent control valve several times before, but technically we call it the evaporative canister purge solenoid, and it's located right in the center of the engine compartment at the back right next to the throttle body. The valve is held on with two 8-millimeter hex head bolts that need to be removed when replacing it. Next, unplug the electrical connector at the top of it, lift up on the tab and then pull out on the connector. Now You have to disconnect the vacuum line going in at the bottom of it. Take a flat blade screwdriver and push it in a little bit on one of the tabs on the side and then pull the hose off. There is an o-ring on the bottom of the valve they can stick a little, just wiggle it while pulling up to remove it.

https://m.youtube.com/watch?v=Ik0zCgl5bPY Hope this helps

Ford Fusion (2017-2020..) fuses and relays

https://fuse-box.info > ford > ford-fusion-2017-2018-f... 2018, 2019, 2020 - The fuse panel is located under the instrument panel to the left of the steering column (behind the trim panel below the steering wheel).

Yes it makes it easier

Chevy for damage or failing rack

we do not know the code either try a local dealer

inside the transmission

chances are the connecting rod under the cowl has come off

These switch's very rarely go bad . Check the voltage at both sides of the inertia switch . Don't BELIEVE anything without testing . Your Fusion has electronic returnless fuel system , a FPDM - fuel pump driver module control's the fuel pump .I'm looking at a fuel pump wiring diagram for your vehicle and it doesn't show a inertia switch anyway . Your best bet , have it towed to the dealer . https://www.youtube.com/watch?v=Rwve6lXriO4&t=625s

watch this video there will be the answer 2007-2010 https://youtu.be/M-o6bseXNsY

Sounds like the battery is flat. Have someone stand in front of the vehicle. Put the headlights on and turn the ignition key. If the battery is flat nothing will happen and the lights won't light. If the battery is very low but has power, the headlights will turn to glow worms when the key is turned. Other possibilities are an activated antitheft system, or a faulty ignition switch. There is also a MAIN FUSE on the positive battery lead!

You require a 32-millimeter axle nut socket for the 2010 Ford Fusion.

The fuel filter on a Ford Fusion is located between the fuel inlet and fuel pump.

No recalls that I can find. Since this vehicle is fairly new and the problem happens often I'd take it to a dealer to have it tested.

You can enter your vin # at the NHTSA.GOV WEBSITE TO CHECK FOR ANY RECALLS ON YOUR CAR IF NONE AND THERE'S A PROBLEM FIX IT AND KEEP THE RECEIPT AND IF A RECALL DOES COME UP FOR THAT PART THEY WILL REIMBURSE YOU FOR IT

I got this free Pdf manual from an online store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the all the times I fixed the chipper in these 4 years

Something is wrong somewhere because they aren't even showing a 2003 ford fusion. The engine number is not coming up either.

If you have test light connect the light to good ground and test both wires the one that light the bulb is positive. If you don’t have one usually the lighter wire is ground then dark is positive hope that help fast to assist you. God bless