20 Most Recent
2009 Chrysler Sebring - Page 3 Questions & Answers
Horn honks 3 or 4
Check for loose wiring or exposed conductor particularly inside the steering column where the horn and the ignition wiring may have come in contact.
WHAT DOSE THE CODE P0335
CODE PO335 CRANKSHAFT POSITION SENSOR CIRCUIT. CODE PO315 - NO CRANKSHAFT POSITION SENSOR LEARNED. POSSIBLE CAUSES, CRANKSHAFT TONE WHEEL FLEX PLATE IS DAMAGED, TONE WHEEL PULSE RING MAY BE DAMAGED, ERRATIC CKP SENSOR SIGNALS WIRING CONNECTOR PROBLEM, CKP SENSOR HAS FAILED, PCM HAS FAILED.
Gear shift will not come
Thanks for choosing FixYa and welcome to the site Sharon. You have a cable that attaches to your shifter. This is what allows the shifter to move. It may be broke or it may have come loose. I would check this first. If it is ok, it might be an issue with your transmission.
How to reset change oil warning
1. Get into your car and shut the door.
2. Put the key into the ignition and turn it on but DON'T start it.
3. Push the gas petal to the floor (all the way to the floor) three time in fairly rapid succession.
4. Wait 5 seconds.
5. Turn the key back and remove it.
6. Now pout the key into the ignition and start it. The light will either be off or go off in a few seconds.
My 09 sebring hesitates often while driving. There
Simple things first.
When was the last time you had a complete tune-up?
Spark plugs, wires, distributor cap rotor (cap), fuel filter, & air filter.These are all simple things that keep you car running efficiently. These, along with the oil and oil filter will protect your motor, improve it's reliability, and maintain gas efficiency.
Check your coolant too... .
How do you kill the engine when locked out the
It's either you drain the fuel from beneath the fuel tank.
or
If you can get to the hood, you can remove the battery terminals. Or along side some fuses.
Sorry about that. Rate this solution.
Chrysler Sebring 2008 convertible top malfunction message
As long as the trunk is open, It won't work. The top has it's own computer. Have the codes read. Takes a scanner. These have like 20 sensors and switches for the top and trunk. You can try to close the latch on the trunk with a screwdriver to get it to work. Another thing is there is a cover that pulls out . This has to be pulled out and latched in place. This will keep it from working also.
Where is the TCM located on a 2005 Chrysler
right in front of the engine compartment fuse box. i believe on these models its integrated with the ecm. its all one unit. there is also a solenoid control unit on the transmission
Not finding what you are looking for?