2009 Cadillac SRX - Answered Questions & Fixed issues

You must remove the deck and send it in for repair.

moved you, to cad gee.

Did you bleed the air out of the system?

Do you get a tail gate ajar light before or after it opens?Have you tried to close it with more force to see if that remedies the problem? When you say "opening on its own" When exactly does it open or do you just notice its open sometimes but don't know when exactly it opened?

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

if it is not stolen, take it to a dealer. that is what a 5/50 warranty is all about. if i wanted to buy cadillac parts, i would go to the parts desk at a cadillac dealer. that seems self evident.

Did they put it on the computer ? Take to a parts store like Autozone or advance or napa, they will check for free and will tell you whats puttunt the cone in your ecm. good luck.

I would check all of the fuses in the inside panel. Each section of the car will be run by a different fuse. Other than that the only other cause could be a short. Which all you have to do is take the piece out and test it with a good power source/change it with one that works to see if it is the unit itself. Have a good one!

No its not and will cause a problem in the long run. The dealer should have sent the repair out to a local muffler shop for welding. Go back to dealer and make them do it, or tell them you are going to call the local GM zone manager!

Try your dealer parts counter.

It sounds like the battery is dead and needs to be charged or replaced, Once the battery has a charge from a battery charger or by having the car boosted with another car to start it, the ignition key's should come out of the ignition. You need power to the electrical system for the ignition to have the keys come out, Note do not force the keys out. Forcing the keys out can and will damage the Pass-lock system to the ignition. Good luck and keep me posted. be glad to know you got your car running again.

Probably something else. These are connected via wiring from them down the inside of the steering column to a connector at the bottom. There will probably be a problem at the connector or in the wiring in the column or from the connector on to the BCM.

i have a Cadillac srx, my 3rd row is now coming up can you help me. i tried the buttons, they make a beeping noise but the seat doesn't come up

Most likely the main fuse may be blown, usually located in from fuse box. but i suggest you check

What year is it ? replace front turn signal ??? You mean the bulb . You may need to remove the headlamp assemble an the bumper cover .

service Stabilitrak light on Take an have DTC'S - diagnostic trouble codes checked , Dealer

Most times when that happens it could be a mechanical blockage. In the tool kit that came with the car there should be a hex tool to manually close the roof. There should be an access panel at the front with a pop off cover. If you remove that cover there should be a female hex that the tool fits into to manually close the roof. If you have the female hex on the sunroof but no tool, most times the correct size allen/hex wrench will do in a pinch. Try opening the sunroof fully with the tool and verify there is nothing in the rails or lead screws the will keep it from closing fully. Also check for a blown fuse to the sunroof.

Door ajar switch possibly . The lift gate not working is a different matter . Could be any number of thing's . Power Liftgate System Components • Liftgate motor assembly • Liftgate latch • Liftgate module (LGM) • Liftgate side upper sensor - left • Liftgate side upper sensor - right • Liftgate handle switch • Liftgate close switch • GMLAN serial data link • PWR LIFT GATE 30 amp fuse • PLG 10 amp mini-fuse Your best bet take it to a qualified repair shop that has the diagnostic tool that can communicate with the lift gate control module , too check for DTC'S - diagnostic trouble code's . Liftgate Module The liftgate module controls the liftgate motor, liftgate clutch, and liftgate latch based on various inputs. The liftgate module also performs diagnostics on these inputs and outputs and will disable liftgate functionality and set DTCs should a fault be detected. The liftgate module is secured to the motor assembly at the left rear of the vehicle. The module requires a liftgate position learn procedure be performed when replacing. This allows the module to learn the full open and full closed positions of the liftgate. DTC B153A 00: Liftgate Latch Switch Signal Circuit DTC B153A 08: Liftgate Latch Switch Signal Circuit Signal Invalid DTC B153B 02: Liftgate Open Switch Signal Circuit Short to Ground DTC B153B 05: Liftgate Open Switch Signal Circuit Open DTC B153E 02: Liftgate Position Sensor Signal Circuit Short to Ground DTC B153E 05: Liftgate Position Sensor Signal Circuit Short to Battery or Open DTC B153E 08: Liftgate Position Sensor Signal Circuit Signal Invalid This is not a job for a diy'er or vehicle owner .

it sounds like the dvd unit has gone faulty

The EVAP purge valve is connected to the EVAP canister and is located at the rear of the vehicle.