2009 Cadillac Escalade EXT - Answered Questions & Fixed issues

It is built into the display that shows what is behind you on the dash.

check your door jam sticker on drivers side.

check your drivers side door jam there should be an inflation sticker .

Tire wear as you outlined is caused either by incorrect toe in or camber setting. Both are components of wheel alignment. Regardless of what you were told, there is no other way that happens.
As to who gets to pay for it depends on your agreement.

In California we lemon laws, hopefully you live in California.

sounds like a bad thermostat to me it sounds like it is partiualy open witch will allow the car to heat up but will not heat the cabin \

PRESS and HOLD LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will sound indicating successful programming. https://repairpal.com/reset-security-system-on-2008-escalade-804#:~:text=PRESS%20and%20HOLD%20LOCK%20and,will%20sound%20indicating%20successful%20programming.

Question edited for clarity. The remote start is tied to the Lift Hatch. Your vehicle was likely not locked, so when you double clicked the lift hatch, it did what it is supposed to do and opened the hatch. If that is not the case, take it to a remote / alarm installer to check the programming.

How To Remote Start A Cadillac Escalade? - VEHQ

https://vehq.com > how-to-remote-start-cadillac-escalade Jan 5, 2022 - 1. Press the lock button on the key fob to secure the vehicle. 2. Press the liftgate button on the key fob twice. Take note that not ... ..

limited info generic answer ---tow--haul switch doesnt have auto level thats a separate system --have scanned for any codes active or pending check fuses relays and sensors

The hardest part is getting the bulkhead connector unhooked. You will need to pull back the rubber accordion cover to access the connector and use a pick to get it unhooked from the pillar. Once the connector is free from the pillar it is pretty straight forward on getting the connector undone and separated. Then just unbolt the door stay and hinges and remove the door. It will make it much easier if you spend the time to remove the front fender first, this will allow you to unbolt the hinges from the pillar while the door is closed and latched instead of trying to support the door while you unbolt the door from the hinges.

transfer case is a one-speed, full time, all wheel drive (AWD ) Nothing you for you to turn it on . It's on all the time , you have a problem with it , take it to the dealer .

In the fuel tank

On this website you finde fuse box diagram and description for Cadillac Escalade mk2 (2003 - 2004) Cadillac Escalade mk2 Second Generation 2003 2004 fuse box diagram Auto...

Front drivers side speed sensor malfunction. Replace the bearing and sensor.

Hi Carolyn: A bit of Sherlock Holmes and you'll find it. - Does it only happen when you are moving? At what speed? - Open the windows one at a time. Can you isolate the area where the sound is coming from? - Check the "mud flap" trim. Any loose bits? - Check under the vehicle for anything loose. - Have someone follow you while you are driving. Ask them to look for anything flapping under the vehicle. - Check the shroud around the fan. Sometimes the retainer pins can come loose. WORK SAFE, and Have fun!. Cheers

Sounds like the scan port is not getting power. check fuses. Usually it is a brown 5 amp fuse. on most vehicles.

Under hood on outside of fuse box

Replace the compressor.

Depending on the vehicle sometimes in the rear 1/4 panel and sometimes under the rear bumper WebRepcurrentVotenoRatingnoWeight

Double Click the DOOR OPEN BUTTON... (or 3-4 times) and that should work. If it does not, then you have an Internal Mechanical Issue.If you can not get it open (Unlocked, You are going to have to take the Panel off and unlock it from the Inside.Be careful NOT to break the Panel, it is a Tight Fit. But you can do it...