20 Most Recent
2009 Audi A4 - Page 4 Questions & Answers
I have a 2009 audi
You have to pull off the seat back cover panel to get access to the clips to remove the headrest. The head rest goes down by pushing down on it, however it locks going up. You will need to push the little button that is either on one the side of the headrest or on one side of the rods on the seat top where the rods enter. Push and lift
7/3/2010 2:37:11 PM •
2009 Audi A4
•
Answered
on Jul 03, 2010
Taking out 2001 Audi A4 Fuel Pump
it is just a matter of unscrewing the cover in the trunk,removing the wires,then unscrewing the pump cover.make sure the fuel tank is not empty as an empty tank is highly explosive.
3/30/2010 1:12:05 PM •
2009 Audi A4
•
Answered
on Mar 30, 2010
I have an hesitation when the car accelerate
I'd have to disagree with this. I don't think there's anything wrong with your carburetor. Myself and my very close friend both have a 2009 A4 and both have the same exact problem. We've reported it to the dealer and they said that over time it should go away. They say it's because the car has a transmission that learns your way of driving. I've had it since July of 09 and it still does it, but I'm used to it now.
2/13/2010 6:57:16 PM •
2009 Audi A4
•
Answered
on Feb 13, 2010
How do i reset the oil change code for a 2009 audi
Simple. Take the possitive cable off the battery, with it laying to the side, get inside the vichecle and turn the ignition on and completely off three times. Re-install the positive cable to the post and this should take care of resetting the computer.
12/8/2009 4:29:53 AM •
2009 Audi A4
•
Answered
on Dec 08, 2009
Location of inertia switch 2005 audi a4 1.8t convertible
no country told, some do not require it. so............
SRS air bags? collision detectors.
a4 not quattro
or just discrete switch at pump fuel
this is Audi not ford, or mazda so do not listen to them ok>?
it's an Audi , but no country told
1.8L turbo??????
the switch is not sold in top store,USA for this exact car.
now I read the service manual to you. USA:
not told a problem with the car, at all just then endless hunts posted here and most fail.
learn that all EFI cars can cut fuel 1 or 2 ways, if spark fails.
pure PCM logic does that to prevent CRASH and burn
other cars with IMMO lamp glowing wrong disables injectors and the pump fuel. both. or just injectors, .
I check
all fuses first
then scan the OBD2 port for DTC errors for sure 100% dead spark.
or test the spark, by hand
there is no switch at the fuel pump, on our a4 period
end hunt
the relay drives the pump via fuse so no not checking all fuses first
is huge huge failure on all cars failing any kind of electrics
then out comes the scan tool or go broke guessing
yes some countries, have laws that mandate a switch be added here or on import.
sorry cars no not the same all over earth and never will be, ever.
sorry,
P1588 Audi fault code . For engine mount sensor
would this sensor going cause the car to go into limp mode? have a slight knock sometimes from under drivers side when car excelorating, now its started going into a limp mode when seemingly on bypasses and motorways but car runs fine on normal roads
How to connect Bluetooth at Audi A4b6 CD player Concert 2 please?
To connect Bluetooth on an Audi A4b6 CD player (Concerts 2), you will need to follow these steps:
- Make sure the CD player is turned on.
- Press the "Menu" button on the CD player to access the main menu.
- Navigate to the "Settings" menu using the arrow buttons on the CD player.
- Select "Bluetooth Settings" from the menu.
- Follow the prompts on the screen to enable Bluetooth on the CD player. This may involve turning on the Bluetooth function on your phone and selecting the CD player from the list of available devices.
- Once the CD player is paired with your phone, you should be able to use the Bluetooth function to make and receive phone calls, stream music, and access other Bluetooth-enabled features.
Not finding what you are looking for?