Lincoln Town Car - Recent Questions, Troubleshooting & Support - Page 7
How do I remove rear window on a Lincoln town car 1994?
Well it is cheaper to replace the window and regulator they will be sold to gather. If it has not been replaced just pull door panel off unplug motor un bolt to screws that hold window in reg. un screw regulator, Some might have rivets grind them off and use not and bolts to replace them plug new motor in to make sure it is not the switch before you take it all apart
Reset the computer after changing the battery ?
You will have to drive it to do that. If you do not have a scan tool go to Advance , auto zone or pep boys they will tell you for free. You do not reset the computer it has to relearn itself
Where is low side A/C port located?
it is the one with the black plastic cap nearest the fire wall passenger side next to the dryer just clip on a/c charger kit go to about 45 lbs r134a the 2 ports are different sizzes anyway
Lincoln
located on the drivers side ( In the trunk ) there is a switch. make sure switch is turned on. When off this will disable your air ride and air ride pump cause- it not to work.. It may have been dis-abled. this could be your problem... Good luck
1999 Lincoln towncar drivers side window won't
The box you're referring to is the "driver's side door control module" if it operates when you press on it you might just have a loose solder connection on the pins. Obviously, you've already removed the inner door panel, so...
1. Unhook neg batt cable
2. Loosen the top screw
3. Press the bottom retaining clips on both sides in and pull back, or just pull back, the screw holds it in and the slots keep the thing steady.
4. Refrain from smashing everything and burning the car to the ground
5. Lightly unclip the three clasps holding the control module board in its housing
6. Visually check for damage, discolouration, loose or broken connectors.
7. Repeat step 4 if you don't find anything
8. Multimeter check or
9. Online parts search
10. Forget step 4.?
Lincoln door latch adjust
On a car of this age you usually have wear at the door hinge and the door starts to sag and it will make it hard to open and close. Find a local body shop, they should be able to change the hinge with either a new part or a good used part to improve your door operation.
Airbag light flashes 4 times and pauses
browntoni22: the code it self is "Potential short in Air Bag system"
CAUTION!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
You are playing with Explosives!!!
Working on a safety restraint system can be very dangerous if you don't know what you are doing. There is a procedure to diagnose the problem which entails using a jumper wire for part of the diagnosis. Just as an example: emissionwiz mentioned a clock spring. This can be damaged by the installer very easily if they don't know what they are doing.
It is designed to rotate only so many revolutions. IF the installer was not paying attention and the clock spring had been out of the packing prior to their receiving it, it could have been rotated one or several revolutions. So when the installer puts the clock spring in place and goes to turn the steering wheel in one direction, it's fine but in the other direction, it will destroy the part!
Anyway, to sum it up in a nutshell, leave this job to a pro.
Not finding what you are looking for?