Lexus Cars & Trucks - Page 5 - Recent Questions, Troubleshooting & Support

all in a timing text box"? wow tall order. the manual is here. https://eautorepair.net/Marketing/Default.asp no options told but consider this. 2007 model year, the RX received a mid-cycle refresh consisting of a new 3.5-liter 2GR-FE V6 replacing the 3.3-liter 3MZ-FE V6 engine on non-hybrid models but is it a hybrid?

cut it off and fit a new one

Question edited for clarity. Question moved to model category. This Club Lexus thread may help you.

O2 sensor heater control circuit fuse? - Lexus Forum Discussion

https://www.clublexus.com > forums > 951271-o2-sens... Aug 27, 2020 - I looked up in the manual and I didn't see a fuse dedicated to O2 sensors heaters. One of the possibilities is the resistor in the sensor ... FUSE help o2 sensors? - ClubLexus - Lexus Forum Discussion Dec 2, 2007 New oxygen sensor reading 0 voltages - ClubLexus Aug 17, 2015 O2 Sensor problem FINALLY SOLVED!!!!!!!!! - ClubLexus Nov 28, 2002 EFI fuse 2 keep blowing - ClubLexus - Lexus Forum Discussion Jul 29, 2020 More results from www.clublexus.com https://www.google.com/search?q=2004+lexus+sc430+heated+oxygen+sensor+fuse ..

inside the box the service manual covers all the, read it?

Check Transmission Fluid level. If that doesn't work, you need the dealership, or a transmission specialist. A high grade scan tool computer can diagnose with engine running, but can also record what is happening whilst the car is being driven. It could be the TCM or it could be shift solenoids. I have a 2005 ES330.

Question edited for clarity. Question moved to model category Fuses 2 or 31 at a guess. Not mentioned specifically. https://fuse-box.info/lexus/lexus-es300-es330-xv30-2001-2006-fuses-and-relay ..

check fuses first. check tranny AFT fluid levels is can hot, idle+ park. well that is super hard stress on that transmission it is stuck in limp home mode.\ do not force it to slip or the clutch pack disks burn up.$$$$$$ 2 kind tranny uses here A760H Automatic Transmission AWD A960E Automatic Transmission IS RWD not scanning the OBD2 (USA)? DLC scan port means you will not know why it fails. and YOU DID, thanks. yes old cars what automatics fail at 200k miles or less and are very expensive to repair,l zillion parts inside it to fail is why, and leaks inside but lets do you a list real service manual quotes. P2714. (the 7 means trans as do all 7s here. shift solenoid valve SLT ECM detects a malfunction on SLT (ON side) according to the speed sensors reading wrong. There are 2 shift solenoids inside the box, SL1 and 2. both valves are bad or pump pressure low (PRNDL test with hand gauge) or transmission has lots of internal seal leaks. P0766

1. SL2 stuck ON malfunction or brake control valve malfunction*:
2. Shifting to 5th and 6th gears is impossible.
3. The ECM determines there is a malfunction when the following conditions are both met.(2-trip detection logic)
   1. When the ECM directs the gearshift to switch to 5th gear, the actual gear is shifted to 4th.
   2. When the ECM directs the gearshift to switch to 6th gear, the actual gear is shifted to 4th.

P0776,same as above C1201 (my guess is tranny stuck on limphome PCM reports it this why) If a malfunction in the engine control system is detected, the operations of VSC and TRAC are prohibited by the fail safe function. When the signals from the engine are input normally, the fail safe is cancelled and the DTC is not stored. C1241.(car battery low below 9.7v due to long cranking? or? This DTC is stored when the IG1 terminal voltage deviates from the DTC detecting condition due to a malfunction in the power supply or charging circuit such as the battery or alternator circuit, etc. is ABS lamp on , or charge/battery fail lamp on in cluster/

I'm not getting any sound from my car stereo I turned the volume up but no sound

I have a 2005! https://www.google.com/search?q=2006+lexus+es330+reset+security+system ..

NO QUESTION ASKED: WHERE ARE THEY?, A1: BEFORE AND AFTER CAT. WHAT DO THEY DO?, (100 PAGE ANSWER) SHORT FUEL TRIM. WHERE CAN I BUY THEM,IN CAR PARTS STORE ANY. WHICH ONES DO AFR AIR FUEL RATIO, A2: FRONTS. ONLY HOW LONG DO THEY LAST, 100K MILES, IMPERIAL( quote Bosch) MUST THEY MATCH MY ENGINE? AND YEAR, YES. must the outside be kept clean ,yes, not let MUD covering them. just wash them off gently, cold. the measure ambient air too, deferentially. offroaders know this and do that.

no bypass --

open the trunk and you'll see the screws when you remove the side covers. also from the outside are screws around the top of the wheel well. you should be able to figure it out from once you start.

I have on 07 is250 and the power windows and trunk release were not working. There is a trunk/valet button in the glove box that needed depressed in order to make them work again.

You need manufacturers equivalent diagnostic equipment to check it

NOT THE CAM BELT RIGHT (CORRECT NAME COG BELT) BUT THE ACCESSORY BELT. LET ME GOOGLE FOR YOU NOW https://parts.lexus.com/p/Lexus_1996_SC-300/Serpentine-Belt/63610390/90916A2007.html THE SERVICE MANUAL COVERS THIS;. BEST IS NO EXACT ENGINE ON THE CAR, AND IF CAR HAS A/C SOME DONT WORLD WIDE.

https://www.google.com/search?q=My+2016+Lexus+200t+F+Sport+driver+side+headlight+and+tire+sensors+went+out+both+at+same+time%2C+what+is+the+cause%3F&client=ms-android-samsung-gj-rev1&sourceid=chrome-mobile&ie=UTF-8#fpstate=ive&vld=cid:57b0604e,vid:AM4P3Elne6c

no year told, at all. you blew out fuses the instuctions told you to first pull main battery 12vdc NEG LUG FIRST AND DID NOT? OR WIRED IT UP WRONG. LEARN TO CHECK CALL CAB FUSE BOXES AND ALL ENGINE BAY TOO. the operators guide in the glove box in hand chapter fuses covers all that. lost it? it is free , in USA are you?

check fuses scan the PCM bingo? tails is old name for PARKing lamps. parks can be 8 or 9 lamps, 4 corners, + and 2 per side. even some mirrors on sides. 10 lamps, area ALL out, or just rear if car has BCM and the BCM runs all that, there my be no fuse (its electronic inside BCM) and if one lamp short all lamps on that one wire all go dead unit the short is cured.)

It could be many things, but as it happened so soon after the timing belt replacement, I would ask them to come and look at it under the repair warranty. Issues like this can only be diagnosed by computer diagnosis.

I have the same annoying problem on my RC350s. It have spent hours trying to fix it but I can't find a fix!!!