Lexus GS 300 - Answered Questions & Fixed Issues - Page 6
Traction control lighting while the car is running
if the light comes on during normal driving not wet or icy out then you need to check your wheel sensors the low traction light indicates the wheels are spinning a different speeds, works in conjunction with the abs system
Vcs/vcsoff /lightsdo not go off
VSC is a system that helps prevent side skids and help stabilize the vehicle while turning on a curve. Is the Check Engine Light on also? (picture of an engine). If the check engine light is on then have someone fix that first because if there is a fault in the engine controls then your vehicle will turn off the VSC system automatically. If no Check Engine Light then either a re-calibration by a repair shop, a bad part in the VSC or the switch is turned off.
Why is my 2006 lexus gs 300 is burning oil
Every single 2006 gs300 will have this problem, and even after it has been "fixed" it's going to happen again due to the intake valves not being washed by incoming fuel. The design of the engine is a poor design and shouldn't have never been put out to production and sold to anybody. Lexus extended the warranty for this problem for 9 years and will not do a single thing for you if you're even one day out of the 9 years. Every single 06 gs300 should have been replaced with a completely different car under the lemon law the moment they realized the problem, but to save the money lexus just swept it under the rug leaving hundreds of thousands of their customers with a lemon.
12/7/2014 6:07:05 PM •
2006 Lexus Gs...
•
Answered
on Dec 07, 2014
•
4,515 views
Trunk won't close
Could be a range of things. Could be the lock jammed open. Need more information.
My Lexus GS 300 won't go over. 20 mph
Its in, what you call limp mode . You need to take it to a garage.they will plug it in. There will be some fault with the car. It goes into limp mode. So no more damage . Can happen.
9/30/2014 8:41:41 PM •
Lexus GS 300...
•
Answered
on Sep 30, 2014
•
1,126 views
What can I do to get my car started after removing and charging the battery
If the security light is flashing, then the alarm has disabled the engine.
Try locking with key remote and unlocking again with key(not remote) and see if that works.
OR put key in turn to ACC and leave for about 5-6mins, switch off and back on to start engine, think thatshould do it.
Let me know if it worked, which one.
Not finding what you are looking for?