Lexus GS 300 - Popular Questions, Answers, Tips & Manuals - Page 5

if the light comes on during normal driving not wet or icy out then you need to check your wheel sensors the low traction light indicates the wheels are spinning a different speeds, works in conjunction with the abs system

Mice living in the air cleaner perhaps? It isn't as daft as it sounds as a car laying undisturbed for a while offers mice a very good home and they love to chew pipes and wiring. The idle air control could be sticking and damp could have got into the oxygen sensors, or anywhere else... Good luck!

It sounds like the kick down or the solenoid Inside the tranny

Look in fuse box for blown fuse

its dripping on the ground if its not going out the tail pipe

Remove the tensioner and replace it.

your car is starting to build up carbon in the intake and cannot keep the air flowing , when you have this kind on miles this is what starts to happen ,you ck eng light will come on with a po 401 shortly

Its in, what you call limp mode . You need to take it to a garage.they will plug it in. There will be some fault with the car. It goes into limp mode. So no more damage . Can happen.

Blocked Exhaust Converter ? Low Fuel Pressure ? Only testing will give you the answer

Hi follow this link , i know it refers to a different model lexus but i'm pretty sure the procedure would be the same, otherwise ring a Lexus dealer and ask them for the procedure but knowing these top marque vehicles they do like to charge for doing very little , hopefully this link will help How to Reset the Anti Theft Lock on Lexus LS400 Sedan eHow

Well code 125 means the engine is not getting hot enough for the emission system to go into closed loop. So you would check the thermostat first. If the engine is reaching normal operating temp of 195 degrees there could be a problem with one of the O2 sensors or the coolant temp sensor.

Bad gas, fuel filter, plugs and wires, oxygen sensor. Not really enough info to tell you specifics

Try fuel filter or catalyc converter.

Could be a faulty injector. Or a problem with the wiring harness or the engine computer.

linear solenoid lockup control malfunction,98 GS300

If the security light is flashing, then the alarm has disabled the engine. Try locking with key remote and unlocking again with key(not remote) and see if that works. OR put key in turn to ACC and leave for about 5-6mins, switch off and back on to start engine, think thatshould do it. Let me know if it worked, which one.

Try catalyic converter, but first check fuel filter.

check the mass air flow meter.

Its on the passenger side wall by your right foot open the door get on your knees and look up on the wall right under the glove compartment.

Have u checkd if they are the right bulbs also try lookin under bonnet for other fuses otherwise if u no how use a multimetre check to c if there is n e power getn to sockets