Lexus IS 300 - Recent Questions, Troubleshooting & Support - Page 4

Depends where you live, can be anywhere from 1.5 -4 thousand. Call a dealer, then a few garages where you live to see what it runs.

Ned, Thank you !! No one has said how you get to those starter bolts for removal. We are going after it now.. My son blew out clutch and we are doing a father son repair. We have removed exhaust, drive shaft and most everything, but that starter has halted everything. Now to get the starter out. That top bolt is not visible from any angle.See attached picturesInternet shot

fuel pump, fuel filter, throttle position sensor, map or maf sensor.

More than likely since your heater core is by-passed,your thermostat was probaly removed and you may be without one.Here's a link to check and replace it.Here's a link to heater core.Your heater core could be bad since it was bypassed,does the front floor board have water stains anywhere.

On the end of the throttle plate shaft. On the opposite side of the accelerator cable.

The fan is usually the problem - does the fan run? If the fan is good, remove the fan and use a mirror and flashlight to inspect the coil. It would be unlikely that the coil is completely plugged but it can happen.

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----

Mostly all types of car no start problems are discussed here with solutions:---

CAR NO START: ENGINE NOT TURNING OVER: http://alltypesofpartsreplacing.blogspot.com/2012/11/car-no-start-engine-not-turning-over.html---------These will help.Thanks.

The code is for a failed throttle control motor or circuit.You might check to see if the throttle control is plugged in, otherwise you may need a shop manual to test the component.