Jaguar S-Type - Recent Questions, Troubleshooting & Support - Page 7
Need location for 02 jag s-type 3.0
the main problem with that car is corroded wiring first thing to check is the wiring behind the front bumper liner and the wiring to the fan module take off the front bumper under liner easy to get to the connectors there is 2 connectors and a small harness to the engine bay fusebox
Chrysler 2004 300m is the catiletic converter welded to the manifold, how is it removed
I can't see anything from here? I looked at an online parts book for a picture of one of your cats, this is what I found. I know from past experience with removing mufflers, clamp or not, they get rusted on there. I usually end up using a hack saw to get it off. Sometimes I have used a metal chisel and a 4# hammer. It's a pain. You have any experience with a cutting torch and welder?
I looked in my database, it didn't have anything, sorry. A muffler shop might be able to help you?
How do you repair a headlight assembly?
you may have dislodged the reflector from the unit housing. retaining fixings remove the lamp assembely and remove the bulbs then try and refit the reflector back in to the retainers by pulling them back through the bulb holder holes
I have a 2000 jaguar
your climate control system is a twin system it has a duel control valve in its normal state it defaults to open both ways unless your heater matrix is blocked then if not the valve has failed or more than likely the wiring to it has corroded. on the valve electrical connector there is 3 wires the centre one is battery positive and normally goes o/c because of corroded wiring around the front bumper liner.check the centre wire using a test lamp like a 21 watt bulb to power load the supply if thats ok then you have to check the wiring back to the climate module the wiring on these cars have been a large prob around the front bumper
My 2001 Jaguar S-Type Interior
that sounds like the door latch assembly is faulty it does not use the same micro switch for door open signal has the interior light
Changed coolant mixing valve added
S type jaag ?? yes immobilisor ,disconnect battery join leads together ,leave for ten mins while you have a cuppa then reconnect battery and it will start .leads must be joined though not just disconnected
Not finding what you are looking for?